Login processing...

Trial ends in Request Full Access Tell Your Colleague About Jove

13.10: Étapes de détermination du taux
TABLE DES
MATIÈRES

JoVE Core
Chemistry

A subscription to JoVE is required to view this content. You will only be able to see the first 20 seconds.

Education
Rate-Determining Steps
 
TRANSCRIPTION

13.10: Rate-Determining Steps

Relating Reaction Mechanisms

In a multistep reaction mechanism, one of the elementary steps progresses significantly slower than the others. This slowest step is called the rate-limiting step (or rate-determining step). A reaction cannot proceed faster than its slowest step, and hence, the rate-determining step limits the overall reaction rate.

The concept of rate-determining step can be understood from the analogy of a 4-lane freeway with a short-stretch of traffic-bottleneck caused due to lane-closure. Like the bottleneck affecting the overall rate at which vehicles could travel, the slowest elementary step influences the net reaction rate.

Rate laws may be derived directly from the balanced chemical equations for elementary reactions. However, this is not the case for most chemical reactions, where balanced equations often represent the overall change in the chemical system, resulting from multistep reaction mechanisms. Therefore, the rate law must be determined from experimental data, and the reaction mechanism subsequently deduced from the rate law.

For instance, consider the reaction of NO2 and CO:

Eq1

The experimental rate law for this reaction at temperatures above 225 °C is:

Eq2

According to the rate law, the reaction is first order with respect to NO2 and first-order with respect to CO. This is consistent with a single-step bimolecular mechanism, and it is possible that this reaction mechanism is valid for this chemical process at high temperatures.

However, at temperatures below 225 °C, the reaction is described by a different rate law that is second order with respect to NO2:

Eq3

This rate law is not consistent with the single-step mechanism, but it is consistent with the following two-step mechanism:

Eq4

The rate-determining (slower) step gives a rate law showing second-order dependence on the NO2 concentration, and the sum of the two elementary equations gives the overall net reaction.

In general, when the rate-determining (slower) step is the first step in the reaction mechanism, the rate law for the overall reaction is the same as the rate law for this step. However, when the rate-determining step is preceded by an elementary step involving a rapidly reversible reaction, the rate law for the overall reaction may be more difficult to derive, often due to the presence of reaction intermediates.

In such instances, the concept that a reversible reaction is at equilibrium when the rates of the forward and reverse processes are equal can be utilized.

For example, consider the reversible elementary reaction in which NO dimerizes to yield an intermediate species N2O2. When this reaction is at equilibrium:

Eq5

This expression may be rearranged to express the concentration of the intermediate in terms of the reactant NO:

Eq6

This approach can be utilized in formulating rate laws for overall reactions when reaction intermediates are present.

Example of Deriving the Rate Law from a Reaction Mechanism

Consider a reaction between nitrogen monoxide and molecular chlorine, for which a two-step mechanism is proposed as shown:

Eq7

This mechanism can be used to derive the equation and predict the rate law for the overall reaction. Initially, by adding the two elementary reactions, the equation for the overall reaction is obtained.

Eq8

To derive a rate law from this mechanism, the rates laws for each of the two elementary steps are written:

Eq9

According to the proposed reaction mechanism Step 2 is the rate-determining step. Hence, the rate law for the overall reaction should be the same as the rate law for this elementary step. However, the rate law for Step 2 contains an intermediate species concentration, [NOCl2]. To modify this, the rate law of the first elementary step is used to derive an expression for the intermediate concentration in terms of reactant concentrations.

Assuming Step 1 is at equilibrium;

Eq10

Substituting this expression into the rate law for Step 2 yields:

Eq11

This text is adapted from Openstax, Chemistry 2e, Section 12.6: Reaction Mechanisms.

Get cutting-edge science videos from JoVE sent straight to your inbox every month.

Waiting X
simple hit counter