المقاومات على التوازي

Resistors are in parallel when one end of all resistors connects to a continuous wire and the other end connects through another continuous wire of negligible resistance. In this configuration, all resistors share the same two terminals, meaning they experience identical potential drops across them regardless of their individual resistance values.

Current through each resistor varies based on its resistance value, calculated using Ohm's law where I = V/R. Since voltage is constant across all parallel resistors, higher-resistance resistors limit more current while lower-resistance resistors allow more current. The sum of individual currents equals the total current drawn from the battery.

For any number of resistors in parallel, the reciprocal of the equivalent resistance equals the sum of the reciprocals of individual resistances: 1/R_eq = 1/R1 + 1/R2 + 1/R3... The equivalent resistance is always less than the smallest individual resistance in the circuit.

Parallel circuits allow each component to operate independently at the full source voltage. If one component fails or burns out, others continue functioning normally. This design principle is used in household wiring and electrical safety systems, where appliances and lights operate independently without affecting each other.

In parallel circuits, all resistors connect between the same two terminals with identical potential drops, while current varies per branch. In series circuits, resistors connect end-to-end with the same current flowing through all, but potential drops vary. Parallel configuration offers independent operation; series does not.

Automobile headlights, taillights, and radios use parallel wiring. Household electrical systems wire outlets, lights, and appliances in parallel so each device operates independently at full voltage. This configuration ensures that turning off one device does not affect others, making it ideal for practical electrical installations.

Use Ohm's law: I = V/R, where V is the constant potential drop across all parallel resistors and R is the individual resistor's resistance. Since voltage is identical across each branch in a parallel circuit, you can directly determine current for any resistor by dividing the voltage by that resistor's resistance value.