تحويل المصدر

Source transformation converts a voltage source in series with a resistor into an equivalent current source in parallel with the resistor, or vice versa. This technique simplifies complex circuits by reducing their complexity while maintaining equivalent electrical behavior. The resistor values remain unchanged during transformation, allowing engineers to analyze circuits more efficiently using nodal analysis with voltage sources or other methods.

Ideal voltage sources have zero internal resistance, while ideal current sources have infinite internal resistance. Source transformation requires non-zero internal resistance to establish equivalence between the two source types. Nonideal sources with finite internal resistance can be transformed, but ideal sources lack the necessary resistance characteristics to create equivalent configurations.

The current source arrow always points toward the positive terminal of the original voltage source. This directional convention ensures consistency and maintains proper circuit orientation throughout the transformation process. Following this rule prevents errors in circuit analysis and helps maintain the correct polarity relationships in the equivalent circuit.

When the original sources are deactivated, the equivalent resistance at the circuit's end terminals remains the same before and after transformation. This principle ensures that the transformed circuit maintains the same electrical characteristics as the original circuit. The resistor values and their configuration preserve the equivalent resistance seen from the circuit terminals.

Apply source transformation to convert voltage sources into current sources, simplifying the circuit into a single current source configuration. Use the current division formula to determine current through the target resistor. Then substitute this current value into Ohm's law to calculate the voltage drop across the resistor.

In source transformation, the series resistance in the voltage source configuration equals the parallel resistance in the current source configuration. When these resistances are equal and the voltage adheres to Ohm's law, the nonideal voltage source becomes equivalent to the nonideal current source. This equivalence ensures that replacing one source with the other does not alter voltage or current characteristics throughout the circuit.

Replacing a nonideal voltage source with its equivalent nonideal current source does not alter the voltage or current characteristics of any element within the circuit. This preservation occurs because both configurations maintain the same equivalent resistance and follow Ohm's law relationships. Source transformation enables circuit simplification while guaranteeing that all element behaviors remain unchanged.