Question 1

What happens to a BJT when the emitter-base junction becomes forward biased?

Accepted Answer

When the emitter-base junction becomes forward biased, the base current increases, which causes the collector current to increase significantly. The transistor transitions from its off-state to an active conducting state, behaving like a closed switch that allows current flow through the device.

Question 2

How does excess minority carrier charge affect BJT switching behavior?

Accepted Answer

The transient behavior of collector current during switching depends on the total excess minority carrier charge stored in the base region. When this charge exceeds the threshold QS, the transistor enters saturation mode. During turn-off, the collector current remains nearly constant until the stored charge reduces back to QS, causing the device to return to active mode before decreasing toward zero.

Question 3

What are the two main operating states of a BJT in a switching circuit?

Accepted Answer

A BJT in a switching circuit operates in two main states: cut-off (off-state) where both junctions are reverse-biased and no current flows, and saturation (on-state) where both junctions are forward-biased and maximum current flows. These states allow the BJT to function as an ideal switch for digital logic applications.

Question 4

Why does collector current remain constant during the turn-off phase?

Accepted Answer

During the turn-off phase, collector current remains nearly constant because excess minority carrier charge is still stored in the base region above the threshold QS. Only after the stored charge reduces to QS does the transistor exit saturation mode and return to active mode, allowing the collector current to gradually decrease toward zero.

Question 5

What triggers the transition between off and on states in a BJT switching circuit?

Accepted Answer

A sudden change in emitter-base voltage, typically initiated by a positive input current pulse, triggers the transition between off and on states. This voltage change alters the bias condition of the emitter-base junction, causing the base current to increase and the transistor to switch from cut-off to saturation mode.

Question 6

What is the significance of the QS charge threshold in BJT switching?

Accepted Answer

QS represents the base charge at zero collector-base voltage and serves as a critical threshold in BJT switching dynamics. When excess charge exceeds QS during turn-on, the transistor enters saturation. When charge reduces to QS during turn-off, the device transitions from saturation back to active mode, controlling the switching speed and efficiency.

Question 7

How does a BJT behave as an ideal switch in digital logic applications?

Accepted Answer

A BJT behaves as an ideal switch by alternating between cut-off and saturation modes in response to input signals. In cut-off, it blocks current flow like an open switch; in saturation, it allows maximum current flow like a closed switch. Understanding the working principle of BJT is essential for designing efficient switching circuits.

تبديل ترانزيستورات BJTs