oscillation-reaction-board-techniques-for-estimating-inertial

Oscillation and Reaction Board Techniques for Estimating Inertial Properties of a Below-knee Prosthesis

The purpose of this study was two-fold: 1) demonstrate a technique that can be used to directly estimate the inertial properties of a below-knee ...

Arizona State University

As a theoretical basis for treatment of carpal tunnel syndrome (CTS) and expanding upon part 1 of this study, the authors investigated the effects of static loading (weights) and dynamic loading (osteopathic manipulation [OM]) on 20 cadaver limbs (10 male, 10 female). This larger study group allowed for comparative analysis of results by sex and reversal of sequencing for testing protocols. In static loading, 10-newton loads were applied to metal pins inserted into carpal bones. In dynamic loading, the OM maneuvers used were those currently used in clinical settings to treat patients with CTS. Transverse carpal ligament (TCL) response was observed by measuring changes in the width of the transverse carpal arch (TCA) with three-dimensional video analysis and precision calipers. Results demonstrated maximal TCL elongation of 13% (3.7 mm) with a residual elongation after recovery of 9% (2.6 mm) from weight loads in the female cadaver limbs, compared to less than 1 mm as noted in part 1, which used lower weight loads and combined results from both sexes. Favorable responses to all interventions were more significant among female cadaver limbs. Higher weight loads also caused more linear translatory motion through the metal pins, resulting in TCA widening equal to 63% of the increases occurring at skin level, compared to only 38% with lower loads. When OM was performed first, it led to greater widening of the TCA and lengthening of the TCL during the weight loading that followed. Both methods hold promise to favorably impact the course of management of CTS, particularly in women.

Manipulative treatment of carpal tunnel syndrome: biomechanical and osteopathic intervention to increase the length of the transverse carpal ligament: part 2. Effect of sex differences and manipulative "priming".

The aim of this study was to review the biomedical literature to ascertain the biomechanical and clinical significance of the lumbar erector spinae flexion-relaxation phenomenon (FRP).

The biomechanical and clinical significance of the lumbar erector spinae flexion-relaxation phenomenon: a review of literature.

The aim of this study was to compare three competitive swimming starts (grab, rear-weighted track, and front-weighted track). The starts were compared in terms of time and instantaneous horizontal velocity, both at take-off from the block and at 5 m from the wall. Twenty US college female swimmers performed three trials of each of the three randomly ordered starts. Swimmers left the block significantly sooner using the front-weighted track start (0.80 s) than the other two starts (both 0.87 s; P < 0.001). In the rear-weighted track start, however, the athletes left the blocks with significantly higher horizontal velocity than in the grab or front-weighted track start (3.99 vs. 3.87 and 3.90 m/s, respectively; each P < 0.001). By 5 m, the front-weighted track start maintained its time advantage over the grab start (2.19 vs. 2.24s; P = 0.008) but not the rear-weighted track start (2.19 vs. 2.21 s; P = 0.336). However, the rear-weighted track start had a significant advantage over the front-weighted track start in terms of instantaneous horizontal velocity at 5 m (2.25 vs. 2.18 m/s; P = 0.009). Therefore, the rear-weighted track start had a better combination of time and velocity than the front-weighted track start. There was also a trend for the rear-weighted track start to have higher velocity at 5 m than the grab start, although this did not reach statistical significance (2.25 vs. 2.20 m/s; P = 0.042). Overall, these results favour the rear-weighted track start for female swimmers even though most of the athletes had little or no prior experience with it. Additional research is needed to determine whether males would respond similarly to females in these three different swimming starts.

Front- or rear-weighted track start or grab start: which is the best for female swimmers?

The purpose of this study was to characterize the force-time profile of the McTimoney toggle-torque-recoil (MTTR) technique.

Force-time profile characterization of the McTimoney toggle-torque-recoil technique.

Movement control responsible for generation of maximal hand velocity was studied on the example of horizontal arm swing that is a component of various sports activities. The movement was performed with the nondominant arm in similarity with the baseball bat swing. The task was to generate maximum hand velocity at a target. The movement included trunk long-axis rotation and horizontal shoulder and elbow extension. Kinematics and torque analyses were performed to study the organization of fastest movements and to compare trials representing the best and worst performance in each subject. Results revealed complex control strategy, with the trunk, shoulder, and elbow playing unique roles in generation of maximal hand velocity. The trunk provided a crucial contribution, directly, rotating the entire arm, and indirectly, exerting interaction torque that caused swift elbow extension. The major role of the shoulder was to transfer the mechanical effect of trunk motion to the elbow. However, the shoulder became the primary motion generator when the trunk reached its limits of rotation, revealing sequential organization of control. The role of the elbow was to maximally comply with passive influence of proximal joints. The findings are discussed in light of the leading joint hypothesis that offers a straightforward interpretation of control of horizontal arm swing as well as practically efficient recommendations for increases in movement speed. The revealed role of intersegmental dynamics in production of high movement speed suggests that movement slowness characteristic for some motor disorders may be partially a compensatory strategy that facilitates regulation of interaction torque.

Multicomponent control strategy underlying production of maximal hand velocity during horizontal arm swing.

It is common practice to study jump landing mechanics by having subjects step off a box set at a certain height instead of landing from a jump. This practice assumes that the landing mechanics are similar between stepping off a box and a countermovement jump as long as the heights can be matched. The mechanics of the two methods had never been compared when landing from identical heights. Thus, the purpose of this study was to compare the mechanics of landing from a countermovement jump to landing from a step-off. Participants performed three maximal countermovement jumps. The mechanics of one countermovement jump was compared with a center of mass fall height matched step-off landing. The step-off landing showed a more rapid time to peak ground reaction force (GRF) in both genders and greater GRF peak and loading rate in males only. No difference was observed between joint angles at initial contact; however, the countermovement jump showed significantly greater joint flexion angles at peak GRF for both genders. EMG showed greater muscle activity during the countermovement jump condition in all subjects. It was concluded that countermovement jump landings are different from step-off landings; thus, results from analyses involving step-off landings should be taken with caution if the aim is to relate them to landing from a jump.

A mechanics comparison between landing from a countermovement jump and landing from stepping off a box.

The purpose of this study was to determine whether joint velocities and segmental angular velocities are significantly correlated with ball velocity during an instep soccer kick. We developed a deterministic model that related ball velocity to kicking leg and pelvis motion from the initiation of downswing until impact. Three-dimensional videography was used to collect data from 16 experienced male soccer players (age = 24.8 +/- 5.5 years; height = 1.80 +/- 0.07m; mass = 76.73 +/- 8.31 kg) while kicking a stationary soccer ball into a goal 12 m away with their right foot with maximal effort. We found that impact velocities of the foot center of mass (CM), the impact velocity of the foot CM relative to the knee, peak velocity of the knee relative to the hip, and the peak angular thigh velocity were significantly correlated with ball velocity. These data suggest that linear and angular velocities at and prior to impact are critical to developing high ball velocity. Since events prior to impact are critical for kick success, coordination and summation of speeds throughout the kicking motion are important factors. Segmental coordination that occurs during a maximal effort kick is critical for completing a successful kick.

Article	Year
Manipulative treatment of carpal tunnel syndrome: biomechanical and osteopathic intervention to increase the length of the transverse carpal ligament: part 2. Effect of sex differences and m... The Journal of the American Osteopathic Association\| PubMed ID: 15863733	2005
The biomechanical and clinical significance of the lumbar erector spinae flexion-relaxation phenomenon: a review of literature. Journal of manipulative and physiological therapeutics\| PubMed ID: 16226632	2005
Front- or rear-weighted track start or grab start: which is the best for female swimmers? Sports biomechanics / International Society of Biomechanics in Sports\| PubMed ID: 18341139	2008
Force-time profile characterization of the McTimoney toggle-torque-recoil technique. Journal of manipulative and physiological therapeutics\| PubMed ID: 19539120	2009
Multicomponent control strategy underlying production of maximal hand velocity during horizontal arm swing. Journal of neurophysiology\| PubMed ID: 19759324	2009
A mechanics comparison between landing from a countermovement jump and landing from stepping off a box. Journal of applied biomechanics\| PubMed ID: 22431209	2012
Mechanical factors associated with the development of high ball velocity during an instep soccer kick. Sports biomechanics / International Society of Biomechanics in Sports\| PubMed ID: 23072048	2012

Richard N. Hinrichs

Biography

JoVE Journal Publications

Other Publications