development-sulfidogenic-sludge-from-marine-sediments

Development of Sulfidogenic Sludge from Marine Sediments and Trichloroethylene Reduction in an Upflow Anaerobic Sludge Blanket Reactor

The importance of microbial sulfate reduction relies on the various applications that it offers in environmental biotechnology. Engineered sulfate ...

INSTITUTO POLITÉCNICO NACIONAL

This article proposes a simple "in-situ" pulse respirometric method for the estimation of four important kinetic and stoichiometric parameters. The method is validated in a suspended biomass nitrifying reactor for the determination of (i) maximum oxygen uptake rate (OUR(ex)max), (ii) oxidation yield (f(E)), (iii) biomass growth yield (f(S)), and (iv) affinity constant (K(S)). OUR(ex)max and f(E) were directly obtained from respirograms. In the presented case study, a minimum substrate pulse of 10 mgNH(4) (+)-N L(-1) was necessary to determine OUR(ex)max which was 61.15 +/- 4.09 mgO(2) L(-1) h(-1) (5 repetitions). A linear correlation (r(2) = 0.93) obtained between OUR(ex)max and the biomass concentration in the reactor suggests that biomass concentration can be estimated from respirometric experiments. The substrate oxidation yield, f(E), was determined along 60 days of continuous operation with an average error of 5.6%. The biomass growth yield was indirectly estimated from the substrate oxidation yield f(E). The average obtained value (0.10 +/- 0.04 mgCOD mg(-1)COD) was in accordance with the f(S) estimation by the traditional COD mass balance method under steady-state conditions (0.09 +/- 0.01). The affinity constant K(S) was indirectly estimated after fitting the ascending part of the respirogram to a theoretical model. An average value of 0.48 +/- 0.08 mgNH(4) (+)-N L(-1) was obtained, which is in the range of affinity constants reported in the literature for the nitrification process (0.16-2 mgNH(4) (+)-N L(-1)).

Kinetic and stoichiometric parameters estimation in a nitrifying bubble column through "in-situ" pulse respirometry.

Numerous reports show that both transfer and uptake of poorly-water soluble substrates are significantly enhanced in two-phase partitioning bioreactors (TPPBs). A number of hypotheses have been put forward to explain these enhancements and among them, the occurrence of direct substrate or oxygen uptake from the vector/water interface has been suggested. The objective of this paper was to quantify the direct oxygen uptake from the vector/water interface in a culture of Pseudomonas putida, performed in a stirred tank reactor, using glucose as substrate and silicone oil as vector. Despite of a sufficient dissolved O(2) concentration in the vector phase (17 mg l(-1)) and a significant vector surface area (4,000 m(-1)) no significant direct O(2) uptake from the vector/water interface was observed, compared to O(2) uptake from the aqueous phase. From these results it was concluded that, direct O(2) or substrate uptake from the vector/water interface might not be significant in TPPBs.

New insights on O2 uptake mechanisms in two-phase partitioning bioreactors.

An in situ respirometric technique was applied to a sequential biofilm batch reactor treating a synthetic wastewater containing acetate. In this reactor, inoculated with mixed liquor from a wastewater plant, unglazed ceramic tiles were used as support media while maintaining complete mixing regime. A total of 8 kinetic and stoichiometric parameters were determined by in situ pulse respirometry; namely substrate oxidation yield, biomass growth yield, storage yield, storage growth yield, substrate affinity constant, storage affinity constant, storage kinetic constant and maximum oxygen uptake rate. Additionally, biofilm growth was determined from support media sampling showing that the colonization process occurred during the first 40 days, reaching an apparent steady-state afterward. Similarly, most of the stoichiometric and kinetic parameters were changing over time but reached steady values after day 40. During the experiment, the respirometric method allowed to quantify the amount of substrate directed to storage, which was significant, especially at substrate concentration superior to 30mg CODL(-1). The Activated Sludge Model 3 (ASM3), which is a model that takes into account substrate storage mechanisms, fitted well experimental data and allowed confirming that feast and famine cycles in SBR favor storage. These results also show that in situ pulse respirometry can be used for fixed-bed reactors characterization.

Kinetic and stoichiometric characterization of a fixed biofilm reactor by pulse respirometry.

Two-phase partitioning bioreactors (TPPBs) are based on the addition of an organic phase, often called vector, to a bioreactor in order to increase mass transfer of oxygen or gaseous substrates from the gaseous phase to the aqueous phase. In TPPBs, like in any other reactor design, the characterization of the bioprocess is often required for design, control, and operation purposes. Pulse respirometry is a method that allows for microbial processes characterization through the determination of several stoichiometric and kinetic parameters with relatively little experimental effort. Despite its interest and its previous application in countless applications, pulse respirometry has never been applied in TPPBs. In this work, pulse respirometry was assessed in a model TPPB degrading terephthalic acid and using Elvax™ as solid vector to enhance oxygen transfer. The results indicated that the addition of 10 to 20% Elvax increased oxygen transfer by up to 97%, compared to control with no vector. Pulse respirometry was successfully applied and allowed for the determination of the growth yield, the substrate affinity constant, and the maximum growth rate, within other. It is concluded that pulse respirometry is a useful method, not only for the characterization of processes in TPPBs but also for the selection of a vector within several brands commercially available.

Pulse respirometry in two-phase partitioning bioreactors: case study of terephthalic acid biodegradation.

Sulfidogenesis in reactors is mostly achieved through adaptation of predominantly methanogenic granular sludge to sulfidogenesis. In this work, an upflow anaerobic sludge blanket (UASB) reactor operated under sulfate-reducing conditions was inoculated with hydrothermal vent sediments to carry out sulfate reduction using volatile fatty acids (VFAs) as substrate and chemical oxygen demand (COD)/SO4 (-2) ratios between 0.49 and 0.64. After a short period of adaptation, a robust non-granular sludge was capable of achieving high sulfate reduction efficiencies while avoiding competence with methanogens and toxicity to the microorganisms due to high sulfide concentration. The highest sulfide concentration (2,552 mg/L) was obtained with acetate/butyrate, and sulfate reduction efficiencies were up to 98 %. A mixture of acetate/butyrate, which produced a higher yielding of HS(-), was preferred over acetate/propionate/butyrate since the consumption of COD was minimized during the process. Sludge was analyzed, and some of the microorganisms identified in the sludge belong to the genera Desulfobacterium, Marinobacter, and Clostridium. The tolerance of the sludge to sulfide may be attributed to the syntrophy among these microorganisms, some of which have been reported to tolerate high concentrations of sulfide. To the best of our knowledge, this is the first report on the analysis of the direct utilization of hydrothermal vent sediments as an alternate source of sludge for sulfate reduction under high sulfide concentrations.

High sulfate reduction efficiency in a UASB using an alternative source of sulfidogenic sludge derived from hydrothermal vent sediments.

Biological methane biodegradation is a promising treatment alternative when the methane produced in waste management facilities cannot be used for energy generation. Two-phase partitioning bioreactors (TPPBs), provided with a non-aqueous phase (NAP) with high affinity for the target pollutant, are particularly suitable for the treatment of poorly water-soluble compounds such as methane. Nevertheless, little is known about the influence of the presence of the NAP on the resulting biodegradation kinetics in TPPBs. In this study, an experimental framework based on the in situ pulse respirometry technique was developed to assess the impact of NAP addition on the methane biodegradation kinetics using Methylosinus sporium as a model methane-degrading microorganism. A comprehensive mass transfer characterization was performed in order to avoid mass transfer limiting scenarios and ensure a correct kinetic parameter characterization. The presence of the NAP mediated significant changes in the apparent kinetic parameters of M. sporium during methane biodegradation, with variations of 60, 120, and 150% in the maximum oxygen uptake rate, half-saturation constant and maximum specific growth rate, respectively, compared with the intrinsic kinetic parameters retrieved from a control without NAP. These significant changes in the kinetic parameters mediated by the NAP must be considered for the design, operation and modeling of TPPBs devoted to air pollution control.

Article	Year
Kinetic and stoichiometric parameters estimation in a nitrifying bubble column through "in-situ" pulse respirometry. Biotechnology and bioengineering\| PubMed ID: 18078297	2008
New insights on O2 uptake mechanisms in two-phase partitioning bioreactors. Biotechnology letters\| PubMed ID: 19838633	2010
Kinetic and stoichiometric characterization of a fixed biofilm reactor by pulse respirometry. Journal of biotechnology\| PubMed ID: 22100265	2012
Pulse respirometry in two-phase partitioning bioreactors: case study of terephthalic acid biodegradation. Applied biochemistry and biotechnology\| PubMed ID: 23274721	2013
High sulfate reduction efficiency in a UASB using an alternative source of sulfidogenic sludge derived from hydrothermal vent sediments. Applied biochemistry and biotechnology\| PubMed ID: 25234397	2014
Assessment of methane biodegradation kinetics in two-phase partitioning bioreactors by pulse respirometry. Water research\| PubMed ID: 25261627	2014

Alberto Ordaz

Biography

JoVE Journal Publications

Other Publications