label-free-single-molecule-detection-using-microtoroid-optical

Label-free Single Molecule Detection Using Microtoroid Optical Resonators

Detecting small concentrations of molecules down to the single molecule limit has impact on areas such as early detection of disease, and fundamental ...

California Institute of Technology

Interactions between the cell and the extracellular matrix regulate a variety of cellular properties and functions, including cellular rheology. In the present study of cellular adhesion, area was controlled by confining NIH 3T3 fibroblast cells to circular micropatterned islands of defined size. The shear moduli of cells adhering to islands of well defined geometry, as measured by magnetic microrheometry, was found to have a significantly lower variance than those of cells allowed to spread on unpatterned surfaces. We observe that the area of cellular adhesion influences shear modulus. Rheological measurements further indicate that cellular shear modulus is a biphasic function of cellular adhesion area with stiffness decreasing to a minimum value for intermediate areas of adhesion, and then increasing for cells on larger patterns. We propose a simple hypothesis: that the area of adhesion affects cellular rheological properties by regulating the structure of the actin cytoskeleton. To test this hypothesis, we quantified the volume fraction of polymerized actin in the cytosol by staining with fluorescent phalloidin and imaging using quantitative 3D microscopy. The polymerized actin volume fraction exhibited a similar biphasic dependence on adhesion area. Within the limits of our simplifying hypothesis, our experimental results permit an evaluation of the ability of established, micromechanical models to predict the cellular shear modulus based on polymerized actin volume fraction. We investigated the "tensegrity", "cellular-solids", and "biopolymer physics" models that have, respectively, a linear, quadratic, and 5/2 dependence on polymerized actin volume fraction. All three models predict that a biphasic trend in polymerized actin volume fraction as a function of adhesion area will result in a biphasic behavior in shear modulus. Our data favors a higher-order dependence on polymerized actin volume fraction. Increasingly better experimental agreement is observed for the tensegrity, the cellular solids, and the biopolymer models respectively. Alternatively if we postulate the existence of a critical actin volume fraction below which the shear modulus vanishes, the experimental data can be equivalently described by a model with an almost linear dependence on polymerized actin volume fraction; this observation supports a tensegrity model with a critical actin volume fraction.

Geometric confinement influences cellular mechanical properties I -- adhesion area dependence.

During migration, asymmetrically polarized cells achieve motion by coordinating the protrusion and retraction of their leading and trailing edges, respectively. Although it is well known that local changes in the dynamics of actin cytoskeleton remodeling drive these processes, neither the cytoskeletal rheological properties of these migrating cells are well quantified nor is it understand how these rheological properties are regulated by underlying molecular processes. In this report, we have used soft lithography to create morphologically polarized cells in order to examine rheological differences between the front and rear zone of an NIH 3T3 cell posed for migration. In addition, we trapped superparamagnetic beads with optical tweezers and precisely placed them at specific locations on the immobilized cells. The beads were then allowed to endocytose overnight before magnetic tweezers experiments were performed to measure the local rheological properties of the leading and trailing edges. Our results indicate that the leading edge has an approximately 1.9 times higher shear modulus than the trailing edge and that this increase in shear modulus correlates with a greater density of filamentous actin, as measured by phalloidin-staining observed through quantitative 3D microscopy.

Article	Year
Geometric confinement influences cellular mechanical properties I -- adhesion area dependence. Molecular & cellular biomechanics : MCB\| PubMed ID: 17937113	2007
Geometric confinement influences cellular mechanical properties II -- intracellular variances in polarized cells. Molecular & cellular biomechanics : MCB\| PubMed ID: 17937114	2007

Judith Su

Biography

JoVE Journal Publications

Other Publications