experimental-protocol-to-investigate-particle-aerosolization-product

Experimental Protocol to Investigate Particle Aerosolization of a Product Under Abrasion and Under Environmental Weathering

The present article presents an experimental protocol to investigate particle aerosolization of a product under abrasion and under environmental ...

Institut National de l'Environnement Industriel et des Risques (INERIS)

In the present work, we investigate the effect of weathering duration on a commercial photocatalytic nanocoating on the basis of its nanoparticle emission tendency into two media, air and water. It is found that increased weathering duration results in stepwise structural deterioration of the nanocoating, which in turn decreases the nanocoating life, changes the nanocoating removal mechanism, and increases the particle emission concentration. Emission of free TiO2 nanoparticles is found to be weathering duration dependent. Three quantities are introduced: emission transition pace (ETP), stable emission level (SEL), and stable emission duration (SED). By linear extrapolation of these quantities from short weathering durations, complete failure of the nanocoatings can be predicted and, moreover, the potential increase of nanoparticles release into the air.

Emission of titanium dioxide nanoparticles from building materials to the environment by wear and weather.

The study presented here focuses on commercial antibacterial tiles whose emissivity of (nano) particles due to abrasion has yet barely been investigated. The tiles have been characterized regarding their surface properties and composition throughout their chain-of-use, i.e. from their state of commercialization until the experimental end-of-service life. In contrast to plane standard tiles, their surfaces form hilly surfaces. In the depressions, titanium dioxide is found at the surface, thus theoretically protected by the hilly areas against abrasion on the tile's surface. Furthermore, a deposition technique has been put in place by producers allowing for coating the before mentioned commercial tiles with titanium dioxide, thus being similar to those commercially available. It consists in depositing titanium dioxide on the surface, latter one allowing fixing the first. This development allows for better understanding the future options for product formulation and thus improvement with respect to particle release. The tests reveal the aerosolization from commercial antibacterial tiles of micronic and submicronic particles in the inhalable region or particles that can subjected to be released in the environment (<10μm). The aersolization of the particles from the coated tiles was found to be significantly higher compared to the non coated tiles.

Article	Year
Emission of titanium dioxide nanoparticles from building materials to the environment by wear and weather. Environmental science & technology\| PubMed ID: 25590625	2015
Environmental release of engineered nanomaterials from commercial tiles under standardized abrasion conditions. Journal of hazardous materials\| PubMed ID: 27321746	2016

Christophe Bressot

Biography

JoVE Journal Publications

Other Publications