finite-element-analysis-model-for-assessing-expansion-patterns-from

Finite Element Analysis Model for Assessing Expansion Patterns from Surgically Assisted Rapid Palatal Expansion

Surgically assisted rapid palatal expansion (SARPE) was introduced to release bony resistance to facilitate skeletal expansion in skeletally mature ...

National Cheng Kung University

Outdoor fitness equipment (OFE) placed in public parks has the potential to encourage physical activity. However, little is known about OFE users and use patterns. This study employed onsite and video observations of OFE usage to describe user characteristics and patterns in Xihu Park. Results indicate that OFE in this park attracted considerable use, particularly in the early morning and late afternoon. During these peak-hour observations, approximately 12 users per hour used the OFE, with the majority being females and seniors. The triple arm stretch and air walker were the most popular stations. However, most OFE users interacted with less than three of the available six OFE stations. Furthermore, users spent an average of less than nine minutes on all OFE stations combined. While OFE equipment was well-used in this urban park, it appears users did not interact with OFE at rates to produce a sufficient bout or level of physical activity during their park visit. Further investigations of OFE are encouraged to determine their health impact.

Who Is Using Outdoor Fitness Equipment and How? The Case of Xihu Park.

Suitable biomechanical properties, good biocompatibility, and osteoconductivity of a degradable magnesium (Mg) alloy make it a potential material for orthopedic implants. The main limitation of Mg is its high corrosion rate in the human body. Surface modification is necessary to improve the Mg corrosion resistance. In this work, a polymeric layer of gelatin/nanohydroxyapatite (Gel/nHA) was coated on a ZK60 Mg alloy by dip coating and spin coating to test the corrosion resistance and biocompatibility in vitro and in vivo. The results from the in vitro test revealed that the coated groups reduced the corrosion rate with the corrosion current density by 59 and 81%, from 31.22 to 12.83 μA/cm and 5.83 μA/cm in the spin coating and dip coating groups, respectively. The dip coating group showed better corrosion resistance than the spin coating group with the lowest released hydrogen content (17.5 mL) and lowest pH value (8.23) and reducing the current density by 45%. In vitro, the relative growth rate was over 75% in all groups tested with MG63, demonstrating that the Mg substrate and coating materials were within the safety range. The dip coating and spin coating groups enhanced the cell proliferation with significantly higher OD values (3.3, 3.0, and 2.5, respectively) and had better antihemolysis and antiplatelet adhesion abilities than the uncoated group. The two coating methods showed no difference in the cellular response, cell migration, hemolysis, and platelet adhesion test. In in vivo tests in rats, the dip coating group also showed a higher corrosion resistance with a lower corrosion rate and mass loss than the spin coating group. In addition, the blood biochemistry and histopathology results indicated that all materials used in this study were biocompatible with living subjects. The present research confirmed that the two methods have no noticeable difference in cell and organ response but the corrosion resistance of dip coating was higher than that of spin coating either in vitro or in vivo.

Article	Year
Who Is Using Outdoor Fitness Equipment and How? The Case of Xihu Park. International journal of environmental research and public health\| PubMed ID: 28430141	2017
Influence of Spin Coating and Dip Coating with Gelatin/Hydroxyapatite for Bioresorbable Mg Alloy Orthopedic Implants: In Vitro and In Vivo Studies. ACS biomaterials science & engineering\| PubMed ID: 36695051	2023

Guan-Lin Wu

Biography

JoVE Journal Publications

Other Publications