薄层色谱法

Wear a lab coat, safety glasses, and nitrile gloves before handling solvents. Change gloves promptly if hexane, ethanol, or ethyl acetate contact them, as these solvents permeate nitrile gloves within minutes. Handle butyl phenyl ether in a fume hood since it is a liquid at room temperature. Store all solvents and solvent mixtures in a flammables cabinet.

Measure approximately 10 mg of the solid compound using an analytical balance into a 20-mL glass vial. Add 10 mL of ethanol and stir with a glass rod until completely dissolved. For liquids like butyl phenyl ether, measure 10.7 μL using a micropipette. Cap and label the vial with the compound name and concentration.

Unknown solutions allow students to identify unknown compounds by comparing their chromatographic behavior to known standards. Crush tablets to powder, measure 10–40 mg depending on the formulation, dissolve in 10 mL absolute ethanol, and stir for 1–3 minutes. Some solid residue may remain. These unknowns are then analyzed alongside the known solutions.

For a 60% hexane and 40% ethyl acetate mixture, measure 60 mL hexane and 40 mL ethyl acetate in separate graduated cylinders, combine in a beaker, and stir until homogeneous. For 90% ethyl acetate and 10% hexane, measure 10 mL hexane and 90 mL ethyl acetate, mix, and stir well. Transfer each to labeled bottles and cap tightly.

Each pair of students needs three 50-mL glass screw-top jars, three 10-mL graduated cylinders, a pencil, labeling pen, tweezers, and a ruler with metric increments. Shared resources include disposable glass capillaries, medium-sized filter papers, and TLC plates. A 254-nm UV lamp and iodine chamber should be available in a central location.

Place 1–2 g of iodine in a labeled 500-mL beaker and cover it with a large watch glass. Set the beaker on a hotplate in a central fume hood. Once students are halfway through the first development, heat the iodine to 110 °C. After the lab, allow the beaker to cool before disposing of iodine waste appropriately.

Nitrile gloves are permeable to hexane, ethanol, and ethyl acetate, allowing these solvents to penetrate within minutes. Changing gloves promptly after solvent contact prevents skin exposure and maintains safety. This is especially critical when handling butyl phenyl ether and other volatile organic compounds used in solution preparation.