4.13
Extracción: Métodos avanzados
Los iones metálicos se pueden separar entre sí mediante complejación con ligandos orgánicos (el agente quelante) para formar quelatos sin carga. En es…
Los iones metálicos se pueden separar por complejación con ligandos orgánicos para formar quelatos sin carga.
El agente quelante debe contener grupos hidrofóbicos y comportarse como un ácido débil, perdiendo un protón para unirse al metal.
El complejo metal-ligando se forma en la fase acuosa y se extrae en la fase orgánica.
El coeficiente de distribución del complejo metálico depende únicamente del pH de la fase acuosa cuando se utiliza un gran exceso de reactivo complejante.
Considere el gráfico de la eficiencia de extracción frente al pH para los iones de cobre (II) y plomo (II).
Cuando el pH de la fase acuosa es inferior a 5, el cobre puede extraerse cuantitativamente en la fase orgánica.
A continuación, el pH se puede amortiguar hasta aproximadamente 9,5 para la extracción selectiva de plomo.
View the full transcript and gain access to JoVE Core videos
Q1: How do chelating agents separate metal ions in extraction?
Chelating agents are organic ligands containing hydrophobic groups that form uncharged complexes with metal ions. These agents behave as weak acids, losing a proton to bind with metals. The metal-ligand complex forms in the aqueous phase and transfers into the organic phase, enabling separation based on partition and distribution coefficients between phases.
Q2: What factors control the distribution of metal-chelate complexes between phases?
The distribution of metal-chelate complexes depends on the pH of the aqueous phase and the ligand concentration in the organic phase, independent of initial metal concentration. When a large excess of complexing reagent is used, pH becomes the primary controlling factor. This pH-dependent behavior enables selective extraction of different metal ions by adjusting aqueous phase pH.
Q3: Why must chelating agents contain hydrophobic groups?
Hydrophobic groups enable the chelating agent to partition into the organic phase and facilitate transfer of the metal-ligand complex from the aqueous phase into the organic solvent. This property is essential for the extraction process, allowing the uncharged metal-chelate complex to move between phases effectively during separation.
Q4: How can copper and lead ions be selectively separated using pH adjustment?
Copper(II) ions can be quantitatively extracted into the organic phase when aqueous pH is below 5.5 using dithizone in carbon tetrachloride. After copper extraction, increasing the pH to approximately 9.5 allows selective extraction of lead(II) ions. This pH-dependent selectivity enables sequential separation of the two metal ions.
Q5: What role does dithizone play in metal ion extraction?
Dithizone is a chelating agent dissolved in carbon tetrachloride that forms colored complexes with metal ions like copper and lead. It enables selective extraction by forming uncharged metal-ligand complexes that transfer into the organic phase. The extraction efficiency depends on pH, allowing sequential separation of different metal ions.
Q6: Why are organic ligands initially added to the organic phase rather than the aqueous phase?
Most organic ligands are insoluble or undergo oxidation in the aqueous phase, making direct addition impractical. By adding the chelating agent to the organic phase first, it can extract into the aqueous phase where it complexes with metal ions. The resulting metal-ligand complex then transfers back into the organic phase for separation.
Q7: How does extraction efficiency relate to pH in metal ion separation?
Extraction efficiency increases with pH changes specific to each metal ion. A plot of extraction efficiency versus pH reveals distinct pH ranges for quantitative extraction: copper extracts below pH 5.5, while lead requires pH near 9.5. This relationship enables selective, sequential extraction of multiple metal ions from a mixture.