Rectificador de media onda

A half-wave rectifier uses a single diode to convert alternating current into unidirectional voltage. During positive half-cycles, the diode becomes forward-biased when input voltage exceeds its threshold, allowing current flow and producing output voltage. During negative half-cycles, the diode remains reverse-biased and non-conductive, resulting in zero output. This creates a pulsating DC that flows only during positive input cycles.

The output voltage in a half-wave rectifier equals the input voltage minus the diode's forward voltage drop during conduction. When the diode conducts during positive half-cycles, this voltage difference appears across the load resistor. During negative half-cycles, the output voltage drops to zero because the diode blocks current flow, resulting in no voltage across the load.

Peak inverse voltage (PIV) is the maximum reverse voltage a diode can withstand without breakdown. In a half-wave rectifier, PIV occurs during negative half-cycles when input voltage reaches its peak in the negative direction, equaling the input voltage peak with reversed polarity. Selecting a diode with adequate PIV rating prevents damage and ensures circuit longevity and reliability.

During positive half-cycles, input voltage exceeds the diode's threshold voltage, creating forward-bias conditions that allow current flow. During negative half-cycles, input voltage falls below the diode's potential barrier, establishing reverse-bias conditions where the diode becomes non-conductive. This directional behavior is fundamental to how diodes rectify AC signals into unidirectional current.

A basic half-wave rectifier requires three essential components: a diode, a load resistor, and an AC power source connected in series. The diode controls current direction, the resistor provides the load path, and the AC source supplies the alternating input signal. This simple configuration forms the foundation of rectification circuits used in power supply applications.

Although the input AC signal has an average value of zero due to equal positive and negative cycles, the half-wave rectifier blocks negative half-cycles entirely. This asymmetry produces a pulsating DC output that flows only during positive input cycles, resulting in a consistent positive average value. The rectification process effectively removes the negative portion of the waveform.

A half-wave rectifier conducts during only positive half-cycles, producing output pulses at half the input frequency with lower average DC value. A full-wave rectifier utilizes both positive and negative half-cycles, delivering output pulses at twice the frequency with higher average DC value and smoother waveform. Full-wave configurations provide more efficient power conversion and reduced ripple.