Smorzamento magnetico

Magnetic damping occurs when eddy currents are induced in a conductor moving through a magnetic field. As the conductor enters or exits the field, magnetic flux changes, inducing eddy currents according to Faraday's law. By Lenz's law, these currents flow in directions that create magnetic forces opposing the motion, quickly reducing oscillations without physical contact.

When a metallic plate enters a magnetic field, eddy currents flow anticlockwise, creating a force opposing entry. When the plate exits, currents flow clockwise, opposing the exit. This directional reversal, governed by Lenz's law, ensures the magnetic force always opposes motion in both directions, producing consistent damping throughout the oscillation cycle.

Slots in a metal plate limit the size of current loops, reducing eddy current magnitude. Additionally, adjacent current loops in slotted plates flow in opposite directions, causing their magnetic effects to cancel. This cancellation significantly decreases the opposing magnetic force, resulting in much weaker damping compared to solid metallic conductors.

Insulating materials experience negligible magnetic damping because eddy currents cannot form in non-conducting materials. Without eddy currents, no opposing magnetic forces develop, allowing the material to oscillate freely. This principle is used in designs where damping must be minimized or avoided entirely.

Laboratory balances use magnetic damping with a conducting disc rotating in a fixed magnetic field. This approach provides ideal damping because the drag force is proportional to velocity and becomes zero at rest. The balance quickly settles after oscillation while maintaining maximum sensitivity and accuracy without friction.

In magnetic damping, the drag force is directly proportional to the velocity of the moving conductor. As velocity increases, the damping force increases proportionally. When velocity reaches zero, the damping force disappears entirely, allowing sensitive instruments like laboratory balances to remain stationary without residual friction.

Eddy currents in conductors can be minimized or prevented by using slotted designs or constructing materials from thin conducting layers separated by insulating sheets. These approaches limit current loop sizes and cause adjacent currents to cancel. This technique is essential in applications where eddy current losses must be reduced.