Cunei

A wedge serves three primary purposes: adjusting the elevation of structural or mechanical parts, providing stability for heavy objects, and splitting a body into two parts. The wedge amplifies an applied force into a much larger force directed almost perpendicular to the initial force, making it easier to manipulate heavy objects with minimal effort.

A wedge converts an applied force into a much larger force directed almost perpendicular to the applied force. This force amplification enables lifting of heavy objects with minimal effort. The wedge's geometry and angle determine how effectively the applied force is converted into the perpendicular lifting force needed to raise the slab.

Seven unknowns exist in wedge motion: the applied force and six normal and frictional forces. These are determined using four force equilibrium equations applied to the wedge and slab, plus three frictional equations applied at each contact surface. The frictional equations equal the coefficient of friction multiplied by their respective normal forces.

When lowering the slab, the frictional forces act in the opposite sense compared to lifting. The direction reversal depends on the motion direction. If the coefficient of friction is very small or the wedge angle is large, the applied force must act to the right to hold the slab in place and maintain equilibrium.

A self-locking wedge occurs when the applied force is removed and friction forces alone hold the block in place. This condition is valid only when the wedge angle is less than twice the angle made by the reaction forces. The wedge's geometry and friction between contact surfaces work together to prevent unwanted movement or slippage.

The weight of the wedge is typically neglected in free-body diagrams because it is small compared to the load being supported. This simplification reduces the complexity of calculations while maintaining accuracy, allowing engineers to focus on the applied force, normal forces, and frictional forces that significantly affect wedge motion and stability.

Wedge angle critically influences both self-locking behavior and applied force needs. A smaller wedge angle promotes self-locking when the angle is less than twice the reaction force angle. Conversely, a large wedge angle reduces the applied force required to hold the slab but prevents self-locking, requiring continuous force application to maintain stability.