キルヒホッフの法則

The junction rule states that the sum of all currents entering a junction must equal the sum of all currents leaving the junction. A junction, also called a node, is a connection point of three or more wires. This rule is based on charge conservation: since current is the flow of charge and charge cannot be created or destroyed, whatever charge flows into the junction must flow out.

The loop rule states that the algebraic sum of potential differences in any closed conducting path must equal zero. This includes voltage sources and resistive elements. The rule is based on energy conservation: the energy supplied by the battery must be transferred into other forms by devices in the loop, with no energy entering or leaving the circuit otherwise.

Sign conventions ensure consistent calculation of potential differences based on travel direction and current direction. For voltage sources, emf is positive when traveling from minus to plus terminals, negative otherwise. For resistors, the sign is negative when travel direction matches current direction, positive otherwise. These conventions prevent calculation errors in complex circuits.

The junction rule applies to currents at connection points and is based on charge conservation, while the loop rule applies to potential differences around closed paths and is based on energy conservation. The junction rule ensures current continuity at nodes, whereas the loop rule ensures energy balance around loops. Together, they enable analysis of any circuit configuration.

Kirchhoff's rules should be used for complex circuits that cannot be analyzed using series-parallel techniques. However, these rules can analyze any circuit, simple or complex. They are particularly essential for circuits with multiple voltage sources, non-standard configurations, or interconnected loops that resist simplification.

Charge conservation is the fundamental principle underlying the junction rule. Since charge cannot be created or destroyed, the total charge entering a junction per unit time must equal the total charge leaving per unit time. Because current is defined as the flow of charge, this principle directly translates to the requirement that currents entering equal currents leaving.

The loop rule uses potential (V) rather than potential energy (U), though they are related by U = qV. In a closed loop, the battery supplies energy that must be completely transferred to other devices. The algebraic sum of potential differences equals zero because the total energy supplied by voltage sources must equal the total energy dissipated by resistive elements.