検流計

A galvanometer consists of two concave-shaped permanent magnets creating a uniform radial magnetic field. A pivoted coil of fine copper wire is placed in this field, with a spring and pointer needle attached to the coil. A calibrated scale below the pointer allows measurement readings when current flows through the coil.

When current flows through the coil, the magnetic field exerts a torque proportional to the current. The coil rotates, and the spring provides a restoring torque. At equilibrium, the angular deflection of the pointer is directly proportional to the coil current, allowing the device to measure currents ranging from microamperes to milliamperes.

Full-scale deflection is the maximum angular displacement of the pointer needle, typically occurring at milliampere current levels. The potential difference required for full deflection can be calculated using Ohm's law, where the coil resistance typically ranges from ten to a thousand ohms.

The spring, similar to a watch hairspring, exerts a restoring torque proportional to the coil's angular displacement. This restoring force balances the magnetic torque, allowing the pointer to reach equilibrium at a position directly proportional to the current, ensuring accurate and stable measurements.

Galvanometers, also called moving coil galvanometers or d'Arsonval galvanometers, are used in car instrument panels, battery chargers, and inexpensive electrical instruments. They measure potential difference, current, or resistance by converting electrical signals into mechanical pointer deflections on a calibrated scale.

Since the coil obeys Ohm's law, the current through it is proportional to the potential difference across the coil terminals. Because meter deflection is proportional to current, the deflection is also proportional to the applied voltage, allowing the galvanometer to measure voltage when properly calibrated.

The essential electrical characteristics are the current required for full-scale deflection and the coil's resistance. These parameters determine the meter's sensitivity and range. Understanding these characteristics is critical when using galvanometers in circuit analysis and when calculating power dissipated in a circuit problem solving scenarios.