6.5
ジョイントの方法： 問題解決 II
Q1: How do you find the angle between truss members in the method of joints?
The angle between truss members is determined using inverse tangent of the ratio of perpendicular lengths. For example, the angle between members AC and AB equals the inverse tangent of BC divided by AB. In this problem, the angle between AC and AB is 67.38°, calculated from the geometry of the truss structure.
Q2: What is the first step when applying the method of joints to solve a truss?
The first step is to draw a free-body diagram of the joint being analyzed. This diagram shows all forces acting on the joint, including applied loads and unknown member forces. All forces must then be resolved into their horizontal and vertical components for equilibrium analysis.
Q3: How are unknown member forces calculated using equilibrium equations?
Unknown member forces are calculated by applying vertical and horizontal force equilibrium conditions at each joint. The sum of forces in each direction must equal zero. For instance, vertical equilibrium at joint A yields the force in member CA as 173.08 N when a 150 N load is applied.
Q4: Why is it necessary to analyze multiple joints sequentially in the method of joints?
Sequential joint analysis is necessary because forces at one joint depend on forces calculated at adjacent joints. After solving joint A, the known forces propagate to joints B and C, then to joints D and E. This systematic progression allows determination of all member forces throughout the truss structure.
Q5: What member forces result from applying the method of joints to this truss problem?
The calculated member forces are: FCA = 173.08 N, FAB = 161.54 N, FBD = 161.53 N, FCD = 173.08 N, FEC = 207.70 N, FED = 138.46 N, and FDF = 265.39 N. These values are obtained by systematically applying equilibrium equations at each joint throughout the truss structure.
Q6: How do support conditions affect the force analysis in a truss?
Support conditions determine the reaction forces at the truss boundaries. A fixed wall support prevents both horizontal and vertical movement, while a roller support allows horizontal movement but prevents vertical displacement. These constraints establish the boundary conditions necessary for solving the equilibrium equations at all joints.
Q7: When should you use the method of sections instead of the method of joints?
The method of sections is preferred when you need forces in specific members without analyzing all joints, or when the truss is complex. It involves cutting through the truss and analyzing a section, making it more efficient for targeted force calculations compared to analyzing every joint sequentially.