ツェナーダイオード

A Zener diode conducts in both forward bias and reverse bias modes, unlike regular diodes that block reverse current. When reverse bias voltage exceeds the Zener's breakdown voltage, current flows through it. This reverse breakdown capability makes Zener diodes ideal for voltage regulation in sensitive electronics applications.

The knee current is the threshold above which a Zener diode exhibits nearly vertical I-V behavior. Beyond this point, the voltage across the Zener remains nearly constant despite increasing current. Operating above the knee current ensures stable voltage regulation, while operation near or below it causes significant voltage variations unsuitable for regulation.

Dynamic resistance, the inverse of the I-V curve's slope, determines voltage stability. Low dynamic resistance maintains constant voltage across varying currents, enhancing regulation effectiveness. High dynamic resistance in low-current regions causes voltage instability, so Zener diodes perform best in high-current regions where dynamic resistance remains low.

Zener diodes have reverse breakdown voltages ranging from a few volts to several hundred volts, allowing them to regulate across diverse voltage applications. Manufacturers specify the exact Zener voltage at a particular test current. This wide voltage range makes Zener diodes adaptable for various sensitive electronic circuits requiring precise voltage control.

Zener voltage varies with temperature, characterized by a temperature coefficient measured in millivolts per degree Celsius. Lower-voltage Zener diodes exhibit negative coefficients, while higher-voltage diodes show positive coefficients. For stable reference voltages with minimal temperature influence, a forward-conducting diode can be paired in series with a positive-coefficient Zener to compensate for temperature variations.

In reverse bias beyond the knee current, the Zener diode exhibits nearly vertical I-V characteristics. As source voltage increases, more current flows through the device, but the voltage across it stays nearly constant. This voltage stability occurs because the incremental resistance remains very low, allowing the Zener to maintain its specified voltage across a wide current range.

Manufacturers specify the Zener voltage at a particular test current and the maximum power dissipation rating. These specifications define the device's operating limits and voltage regulation capability. Understanding these parameters ensures proper selection and safe operation of Zener diodes in voltage regulation circuits.