電力システムの 3 相短絡

Synchronous machines are modeled as constant voltage sources positioned behind their subtransient reactances. This representation captures the immediate response of generators and motors during fault conditions. The subtransient reactance reflects the machine's initial impedance to fault current, enabling accurate prediction of fault behavior and system stability during the first few cycles of the fault.

Winding resistances, series resistances, shunt admittances, delta-Y phase shifts, armature resistance, saturation, saliency, non-rotating impedance loads, and small motors below 50 horsepower are excluded because their impact on subtransient fault current is negligible or complicates analysis without significantly affecting results. This simplification allows engineers to focus on dominant reactance effects during the critical initial fault period.

Superposition is used by representing the fault using two opposing voltage sources with equal phasor values. This approach allows the system to be simplified by removing the phasor value, thereby isolating the fault current component for easier calculation. The method combines contributions from both the generator and motor to determine total fault current accurately.

Transformers are modeled using their leakage reactances, while transmission lines are represented by equivalent series reactances. These reactances dominate the impedance seen by fault current and are essential for accurate modeling. By focusing on these key reactances, engineers can predict system behavior during faults and design protective equipment like circuit breaker and fuse selection appropriately.

The subtransient fault current represents the maximum initial stress on system components during a fault. Predicting this current helps engineers design systems that can withstand fault events, maintain system stability, and minimize potential damage. Understanding the immediate effects of faults on the power system ensures reliability and safety, allowing for effective mitigation strategies during fault conditions.

When a three-phase short circuit occurs, the fault causes a voltage drop at the fault point. The pre-fault internal voltages of synchronous machines are represented behind their subtransient reactances. Using superposition, engineers calculate the resulting fault current by analyzing the system before and after the fault, predicting how voltage collapses and current surges during the fault event.

Both the generator and motor contribute to the total fault current during a three-phase short circuit. The procedure considers contributions from each component by applying appropriate reactances and initial circuit conditions. Accurately modeling these contributions ensures the analysis accounts for the immediate effects of the fault on the entire power system, enabling effective fault management and system protection.