Question 1

Why does SEM provide better resolution than light microscopy?

Accepted Answer

SEM uses electrons instead of light, avoiding diffraction limitations that restrict light microscopes to 200 nm lateral resolution and 1,000X magnification. Electrons enable SEM to achieve sub-nanometer resolution and magnifications exceeding one million times, making it ideal for analyzing nanoscale structures like catalyst particles.

Question 2

What is the purpose of coating non-conductive samples with metal in SEM?

Accepted Answer

SEM requires samples to be conductive for conventional imaging. Non-conductive samples are coated with a thin metal layer, typically gold, to enable electron conductivity. This conductive coating allows the electron beam to interact properly with the sample surface and generate detectable secondary and backscattered electrons.

Question 3

How do secondary and backscattered electrons differ in SEM imaging?

Accepted Answer

Secondary electrons are emitted from the sample surface and vary in intensity based on surface angle, creating a 3D appearance with darker perpendicular surfaces and brighter edges. Backscattered electrons reflect opposite to the beam direction and increase in intensity with atomic number, enabling compositional analysis of the sample surface.

Question 4

What is astigmatism in SEM and how is it corrected?

Accepted Answer

Astigmatism is asymmetrical beam distortion that causes image blurring even when the sample is well-focused. To correct it, increase magnification to maximum, focus using fine focus, then adjust stigmation controls in both x and y directions to reshape the electron beam until the image is optimally focused.

Question 5

How does depth of field in SEM compare to light microscopy?

Accepted Answer

SEM provides up to 300 times greater depth of field than light microscopy because it is not limited to imaging features only in the focal plane. Objects outside the focal plane are resolved in SEM rather than appearing blurry, enabling clear three-dimensional visualization of complex sample structures.

Question 6

What operating parameters should be adjusted when imaging different material densities?

Accepted Answer

Select accelerating voltage based on material density: higher voltages up to 30 kV for high-density materials and lower voltages starting at 1 kV for low-density materials. The electron beam energy determines penetration depth, so voltage selection directly affects image quality and compositional information obtained from the sample.

Question 7

How is SEM used for sample preparation for analytical characterization?

Accepted Answer

SEM enables detailed imaging of samples prepared for analytical analysis, allowing visualization of surface morphology, porosity, and three-dimensional structure before further characterization. This imaging capability helps verify sample quality and identify regions of interest for subsequent analytical measurements or compositional studies.

走査型電子顕微鏡 (SEM) - 評価クイズ