5.12
손 씻기의 시술 전 단계에는 보석을 벗기고 소매를 올리는 것이 포함됩니다. 그러나 많은 조직에서 직원들이 결혼 반지를 착용할 수 있도록 허용합니다.
손 씻기 절차 자체는 다음과 같은 단계를 포함합니다. 먼저, 손에 상처가 있는 경우 방수 붕대로 손을 덮습니다. 상처와…
전체 손 씻기 절차는 오염 정도에 따라 약 40초에서 60초가 소요됩니다. 스크러빙에는 최소 20초가 필요합니다.
세탁을 시작하기 전에 반지, 팔찌 또는 손목시계를 모두 제거하고 소매를 걷어 올려야 합니다.
긴 소매는 손목 씻기를 방해하고 빠른 재오염을 유발할 수 있으며, 장신구나 손목시계를 착용하면 손 씻기 후 액세서리 위와 아래에 미생물이 남아 있을 수 있으므로 가능한 한 피하는 것이 가장 좋습니다.
손의 상처는 피부가 갈라지면 잠재적인 병원균이 침투할 수 있으므로 방수 드레싱으로 덮어야 합니다.
손톱은 먼지와 박테리아를 옮길 수 있으므로 매니큐어나 인조 손톱 없이 짧고 깨끗하게 유지해야 합니다.
손씻기를 시작하려면 물이 튀는 것을 방지하는 유속으로 수돗물을 켜고 편안하게 따뜻해질 때까지 흐르게 하십시오.
따뜻한 물은 편안하고 피부의 유분을 제거합니다.
그런 다음 손과 손목을 물로 적시고 모든 표면을 덮을 만큼 충분한 비누를 바릅니다.
비누는 물로 거품을 내어 손 씻기를 가속화하고 먼지, 유기 물질 및 미생물을 제거합니다.
View the full transcript and gain access to JoVE Core videos
Q1: Why should jewelry and watches be removed before handwashing?
Jewelry and wristwatches allow microorganisms to remain on and beneath the accessories even after handwashing, preventing effective decontamination. Removing these items ensures all hand surfaces are properly cleaned and reduces infection risk. Many organizations allow wedding rings as an exception to this requirement.
Q2: How long does a proper handwashing procedure take?
The entire handwashing procedure takes approximately 40 to 60 seconds, depending on the extent of contamination. A minimum of 20 seconds is required for scrubbing to effectively remove dirt, organic material, and microorganisms from all hand surfaces. Adequate time ensures thorough decontamination.
Q3: What should be done about cuts or abrasions on the hands before washing?
Any cuts on the hands should be covered with a waterproof dressing before handwashing. Breaks in the skin may allow potential pathogens to gain entry, and repeated handwashing can worsen an injury. Waterproof dressings protect the wound while allowing proper hand hygiene.
Q4: Why is nail hygiene important in handwashing procedures?
Fingernails should be kept short and clean, without nail polish or artificial nails, as these can harbor dirt and bacteria. Long nails, fake nails, and nail polish imperfections are not entirely removed by handwashing, making proper nail maintenance essential for infection prevention.
Q5: What is the correct way to turn on the tap water for handwashing?
Turn on the tap water at a flow rate that prevents splashing and direct the water flow away from the drain. Drain openings are often contaminated with microorganisms that could be transferred to the environment or user if splashing occurs. Allow water to run until it feels comfortably warm.
Q6: Why should sleeves be rolled up before handwashing?
Long sleeves hinder the washing of wrists and can cause quick re-contamination after handwashing. Rolling up sleeves ensures wrists are fully accessible for cleaning and prevents contaminated fabric from recontaminating clean hands. This step is essential for maintaining hand cleanliness throughout the procedure.
Q7: How should soap be applied during the handwashing procedure?
Apply enough soap to cover all hand surfaces after wetting hands with water. Soap lathers with water to speed up handwashing and removes dirt, organic material, and microorganisms. Applying soap directly onto dry hands may damage the skin, so hands should be wet first.