표본 주입 시스템

A microsyringe injects the sample solution into a heated sample port, where it is completely vaporized and mixed with the carrier gas. This vaporization process ensures the sample is properly prepared as a vapor plug for introduction into the chromatographic system, enabling high efficiency and resolution during analysis.

Split injection uses a split valve to allow only a small proportion of the sample to reach the column, making it ideal for concentrated samples and preventing column overload. Splitless injection closes the split valve to permit the maximum amount of sample to reach the column, preferred for trace analytes where sensitivity is critical.

Splitless injection closes the split valve to permit the maximum amount of sample to reach the column, maximizing sensitivity for detecting low-concentration analytes. This method increases the signal strength needed to identify trace compounds, though it requires careful sample concentration management to avoid column saturation.

Split injection directs only a small proportion of the sample to the column based on the split ratio, protecting the column from overload with concentrated samples. Splitless injection maximizes sample delivery but is reserved for dilute samples. Together, these methods enable analysis over a wide concentration range while maintaining column efficiency and lifetime.

Thermally sensitive samples are injected directly into the column and volatilized by slowly increasing the column temperature rather than using the heated sample port. This gradual temperature increase prevents thermal degradation, allowing sensitive compounds to be analyzed without decomposition while maintaining sample integrity.

The heated sample port completely vaporizes the injected sample and mixes it with the carrier gas, creating a vapor plug for introduction into the column. This process ensures uniform sample distribution and proper interaction with the carrier gas, which is essential for achieving high efficiency and resolution in gas chromatography.

The split ratio determines what proportion of the vaporized sample reaches the column while the remainder exits through the split vent. By adjusting the split ratio, analysts can control sample concentration entering the column, preventing overload with concentrated samples and extending column lifetime while maintaining analytical accuracy.