원자 방출 분광학: 연구실

ICP is preferred for AES because it offers high stability, low noise, and minimal interference under accurate experimental conditions. These characteristics make it ideal for analyzing solution samples and provide superior quantitative analytical data compared to other plasma sources, though newer microwave sources are emerging as cost-effective alternatives.

Plasma emission spectroscopy primarily analyzes liquid samples but also allows direct analysis of solid samples through electrothermal vaporization, laser ablation, spark ablation, and glow-discharge vaporization. This versatility makes it suitable for diverse analytical applications across different sample matrices and material types.

Elements like boron, carbon, nitrogen, phosphorus, and sulfur require vacuum spectrometers because their emission lines fall below 180 nm, causing atmospheric interference. Alkali metals also pose challenges due to unsuitable operating conditions and their near-infrared emission lines, limiting detection in spectrometers designed for ultraviolet radiation.

Plasma emission spectrometry can qualitatively identify and quantify approximately 60 elements from the periodic table. Most elements have several prominent spectral lines suitable for identification and quantification, with line selection based on overlap with other elements present in the sample.

Calibration curves are linear plots of electrical signals proportional to line intensity against analyte concentration. These curves enable quantitative analysis by establishing the relationship between measured emission intensity and known analyte concentrations, though departures from linearity can occur due to self-absorption or detection system responses.

Internal standards are preferred when factors like excitation source temperature and atomization efficiency significantly affect emission intensity beyond control. Internal standards have similar emission lines and chemical interferences to the analyte, compensating for variations in source parameters that external standards cannot address.

Internal standards compensate for uncontrollable variations in excitation source temperature and atomization efficiency that affect emission intensity. By using reference elements with similar emission lines and chemical interferences to the analyte, internal standards improve measurement accuracy when external standards cannot account for these parameter fluctuations.