클램퍼 회로

A clamper circuit consists of three essential components: a time-varying input signal, a capacitor, and a diode. The output voltage is measured across the diode rather than the capacitor, distinguishing it from standard rectifier circuits. This configuration allows the circuit to adjust the baseline of waveforms by restoring the DC component.

During the negative half-cycle, the diode becomes forward-biased, resulting in zero voltage across the diode while the capacitor charges to the peak input value. During the positive half-cycle, the diode becomes reverse-biased, and the input voltage combined with the charged capacitor produces an output voltage twice the input voltage, demonstrating the circuit's voltage-doubling capability.

When a load is connected across the diode, output current flows through the capacitor, causing the output voltage to decrease exponentially according to the RC time constant. As input voltage decreases, the output follows and recharges the capacitor. This load effect subtly alters output voltage but the capacitor replenishes charge in steady-state conditions.

A clamper circuit is called a DC restorer because it reinstates the DC component of signals that have been stripped by capacitive coupling. By adjusting the waveform baseline, the circuit restores the DC level necessary for accurate duty cycle modulation in pulse signal transmission through capacitively coupled systems.

Altering the diode's polarity inverts the clamping effect. Instead of raising the lowest point of the waveform, reversing the diode orientation clamps the waveform's highest peak at zero volts. This flexibility allows the circuit to adapt to different signal processing requirements depending on application needs.

The output voltage equals the original input waveform elevated by a value equal to the voltage across the capacitor. The capacitor charges to the peak value of the input signal during forward bias, then locks this voltage at a constant level when the diode becomes reverse-biased, directly determining the output voltage shift.

While both circuits can produce output voltages greater than the input, a clamper measures output across the diode and adjusts waveform baseline by restoring DC components. A voltage doubler circuit, by contrast, is specifically designed to produce an output voltage approximately twice the input peak value through different component configurations and operating principles.