17.6
Stress: algemene beladingsomstandigheden
Om de complexiteit van reële omstandigheden te begrijpen waarbij meerdere belastingen tegelijkertijd op een constructie worden uitgeoefend, zou je een…
Consider a body subjected to multiple loads. When dissected through a point using a plane parallel to the xy plane, it is observed that the shearing forces act on a small area surrounding the point.
Consider a portion of the body subjected to the previously shown loads, with the normal force acting along the z-axis
The shearing forces do not have a well-defined direction on a sectional plane, so they are resolved into two component forces parallel to the x and y axes.
The magnitude of each force is then divided by the area to obtain the stress components.
The first subscript in the stresses indicates that they are exerted on the surface perpendicular to the z-axis. The second subscript in shearing stresses identifies the direction.
When the other side of the vertical plane is analyzed, it yields the same stress components but in opposite directions.
By passing sections through the point parallel to the yz and zx planes, additional stress components can be defined.
View the full transcript and gain access to JoVE Core videos
Q1: What are stress components and how are they determined at a point in a loaded body?
Stress components are determined by passing a sectional plane through a point in a body and analyzing forces acting on that section. Normal forces and shearing forces are resolved into components parallel to coordinate axes. Each force component is then divided by the area to obtain stress values. This process yields three distinct stress components at any point when sections are passed parallel to different planes.
Q2: What do the subscripts in stress notation indicate?
In stress notation, the first subscript indicates the plane on which the stress acts—specifically, the direction of the surface normal. The second subscript identifies the direction of the stress component itself. For example, τzy indicates shearing stress acting on a surface perpendicular to the z-axis, directed along the y-axis. This notation system clarifies both location and orientation of each stress component.
Q3: How do shearing forces differ from normal forces in stress analysis?
Normal forces act perpendicular to a sectional plane, typically along one axis. Shearing forces, however, lack a single well-defined direction on the sectional plane and must be resolved into two component forces parallel to the coordinate axes. This resolution allows shearing stresses to be calculated by dividing each component by the section area, yielding multiple shearing stress components at a point.
Q4: Why do opposite sides of a sectional plane show stress components in opposite directions?
When analyzing opposite sides of a vertical plane through a point, Newton's third law applies: action and reaction forces are equal and opposite. Therefore, the stress components calculated on one side of the plane are identical in magnitude but opposite in direction on the other side. This symmetry reflects the equilibrium of forces within the body under load.
Q5: How many stress components exist at a point in a three-dimensional loaded body?
At any point in a three-dimensional body, nine stress components exist: three normal stresses (σx, σy, σz) and six shearing stresses (τxy, τyx, τxz, τzx, τyz, τzy). These components are determined by passing sectional planes parallel to the xy, yz, and zx planes through the point. Together, they fully describe the stress state at that location under general loading conditions.
Q6: What do positive and negative signs indicate in stress component values?
The signs of stress components indicate the type of loading: positive values represent tension, where the material is being pulled apart, while negative values represent compression, where the material is being pushed together. This sign convention applies to both normal and shearing stress components, allowing engineers to quickly identify whether a region experiences tensile or compressive loading.
Q7: How does analyzing multiple sectional planes help understand stress under complex loading?
Analyzing sections parallel to different coordinate planes reveals the complete stress state at a point. By examining sections parallel to xy, yz, and zx planes, all nine stress components become defined. This comprehensive approach unravels the complex interplay of forces and stresses under intricate loading conditions, enabling accurate prediction of material behavior and structural failure.