Een abonnement op JoVE is vereist om deze inhoud te bekijken. Log in of start vandaag met uw gratis proefperiode.

Methodenartikel

Continuous Monitoring of Biological Noise in Bacteria Using Time-Lapse Microscopy

420 weergaven

28 november 2025

In dit artikel

Samenvatting

Source: Chaimovitz, E. A., et al. Continuous Measurement of Biological Noise in Escherichia Coli Using Time-lapse Microscopy. J. Vis. Exp. (2021)

This video demonstrates real-time visualization of biological noise in E. coli by tracking fluctuations in GFP fluorescence during bacterial growth and division using time-lapse microscopy.

Protocol

  1. Preparing the sample for microscopy imaging
    1. Remove the flask from the water bath. Wipe the outside of the flask clean and let it cool to room temperature (25 °C).
      NOTE: Remove the flask about 3 minutes before the timer ends.
    2. Pour 3 mL of the gel constantly to the plate perimeter in a circular motion. Leave to solidify for a few minutes.
    3. Seal plates with tape and pierce several holes with 25 G needle. Flip all the dishes to prevent water condensation from dripping onto the gel.
    4. Incubate all the dishes at 4 °C for 30 min to allow full solidification while preventing cell mitosis.
      NOTE: Leave samples at 4 °C for successive measurements, no more than one day.
    5. Start the microscope per manufacturer's instructions.
    6. Find the initial focus using the lowest amplification lens and engage the automatic focus system (AFS).
    7. Use oil if needed, drown the lens with oil and spread it carefully by moving the plate with a platform controller (not manually), and AFS can be engaged again.
    8. Use relative cross-section in Z direction, following the default suggestion for Z step cross-sections.
      NOTE: Take bright field images every 5 minutes and fluorescent images every 20 minutes. Sometimes the focus needs to be adjusted during the first 30 minutes. Preheating the microscope incubator box and oil, while refrigerating the sample tends to help reduce the initial loss of focus.

Toegang beperkt. Log in of start een proefperiode om deze inhoud te bekijken.

Materialen

Lijst van materialen gebruikt in dit artikel
NaamBedrijfCatalogusnummerOpmerkingen
35mm Glass dishMattekP35G-0.170-14-CThickness corresponding with microscope lens.
AgaroseLonza5004LB preperation
Eclipse TiNikon Inverted microscope
Immersol 518FZeiss4449600000000Immersion oil
Parafilm tapeBemisPM-996Refered to as tape in text

Tags

GFP-fluorescentieEscherichia coligenexpressieconfocale microscopieagarosegelbacteriële groeiceldelingfluorescentie-imaging