Preparing a Single-Cell Suspension of Immune Cells from Murine Brain Tissue

Samenvatting

Source: DiSano, K. D., et al. Isolating Central Nervous System Tissues and Associated Meninges for the Downstream Analysis of Immune Cells. J. Vis. Exp. (2020).

The video demonstrates the preparation of a single-cell suspension of immune cells from a murine brain tissue. It involves enzymatic digestion to release cells from the brain tissue, followed by density gradient centrifugation to isolate the immune cells based on their densities to obtain the single-cell suspension.

Protocol

All procedures involving animal samples have been reviewed and approved by the appropriate animal ethical review committee.

1. Preparing single-cell suspensions of brain and spinal cord tissue

1. Transfer the brain or spinal cord tissue with media to the top of the 100 mm Petri dish by pouring the tissue and media from the tube. Using forceps, move the tissue to the bottom of the Petri dish. Finely mince the brain or spinal cord with a sterile razor blade. Using the razor blade, move the minced tissue to the bottom of the plate by scraping to gather the tissue.
   NOTE: For the enzymatic digestion protocol below, up to two spinal cords may be pooled together for processing. Brains should be processed individually.
2. Using a 5 mL serological pipette, add 3 mL of RPMI (Roswell Park Memorial Institute medium (supplemented with 10% fetal calf serum (FCS) to the Petri dish. Using a 10 mL serological pipette, pipette up and down to resuspend the tissue in the media and transfer to a 15 mL conical tube.
   NOTE: If the downstream application is single-cell or bulk RNA sequencing analysis or cell culture, FCS lots should be tested to ensure cells are not activated prior to analysis. Alternatively, cells can be processed using 1x PBS with 0.04% BSA instead of RPMI with 10% FCS.
3. Using a 10 mL serological pipette, wash the Petri dish with an additional 2 mL of media to collect any residual tissue and transfer to a conical tube for a 5 mL total volume. Keep the tubes on ice between processing steps.
4. Using a pipette, resuspend the collagenase I powder in Hank's Balanced Salt Solution (HBSS) media to obtain the desired concentration (i.e., 100 mg/mL). Add collagenase type I to the conical tube containing the minced tissue sample to obtain the desired final concentration (i.e., 50 µL for 1 mg/mL).
   NOTE: Higher concentrations of collagenase will increase cell yields but can cleave cell surface markers. Therefore, collagenase I lots should be titrated to determine the optimal concentration needed to obtain the highest number of viable cells with all required cell surface markers intact. For example, collagenase I was tested at final concentrations of 0.5 mg/mL, 1 mg/mL, and 2 mg/mL on single brain or spinal cord samples. Cell viability was determined using the trypan blue exclusion method and cell surface markers CD45, CD19, and CD4 were assessed by flow cytometry. A 1 mg/mL concentration of collagenase I yielded the highest live cell count while retaining all cell surface markers of interest. Thus, this concentration was used for further experiments examining these cell types.
5. Gently resuspend DNase I powder using 0.15 M sodium chloride to the desired stock concentration. Add the resuspended DNase I to the conical tube containing the minced tissue sample to obtain a final concentration of 20 U/mL.
   NOTE: DNase I lots vary by units of activity per mL. The concentration to be added to the tissue sample will change based on the stock vial's units of activity per milliliter. The final desired concentration per sample is 20 U/mL.
6. Place the tubes in a tube rack in a 37 °C water bath and incubate for 40 min. Invert the tubes every 15 min to thoroughly mix the tissue with the enzymes. After incubation, add 500 µL of 0.1 M EDTA (pH = 7.2) to each tube for a final concentration of 0.01 M EDTA and incubate for an additional 5 min to inactivate the collagenase.
7. Using a 10 mL serological pipette, add 9 mL of RPMI supplemented with 10% FCS to each tube to bring the volume of each tube to ~14.5 mL. Centrifuge at 450 x g for 5 min at 4 ˚C. Using a Pasteur pipette with a vacuum, aspirate the supernatant, being careful not to touch the cell pellet.
8. Using a 5 mL serological pipette, add 3 mL of 100% stock isotonic density gradient solution to the tube containing the cell pellet. Using a 10 mL serological pipette, add additional RPMI 10% FCS media to bring the final volume to 10 mL and resuspend the cell pellet to create a 30% stock isotonic density gradient solution layer.
   NOTE: Prepare the 100% stock isotonic density gradient medium in advance, aliquot, and store at 4 °C for up to 3 months. To prepare the 100% stock isotonic density gradient solution, dilute the density gradient media (Table of Materials) with density gradient media dilution buffer. Prepare the density gradient media dilution buffer (80.0 g/L NaCl, 3.0 g/L KCl; 0.73 g/L Na₂HPO₄, 0.20 g/L KH₂PO₄; 20.0 g/L glucose) and filter sterilize using a vacuum filter system. Make the 100% stock isotonic density gradient solution by mixing 1 part of the density gradient dilution buffer and 9 parts density gradient media. Mix well.
9. Invert and mix each tube well prior to adding the 70% stock isotonic density gradient solution underlay. Insert a 1 mL serological pipette containing 1 mL of 70% stock isotonic density gradient solution into the bottom of the tube. Slowly underlay 1 mL of the solution, being careful not to make bubbles. Slowly remove the serological pipet from the tube, being careful not to disturb the gradient.
   NOTE: For the 70% underlay, the 100% stock isotonic density gradient solution should be diluted to 70% using RPMI media (i.e., 7 mL of 100% stock isotonic density gradient solution and 3 mL of RPMI media mixed well). Additionally, creating a clean, undisturbed 70% underlay is essential for the removal of myelin debris and for obtaining pure single-cell suspensions at the gradient interface following centrifugation.
10. Centrifuge at 800 x g for 30 min at 4 °C with no brake. Aspirate the supernatant, including the myelin debris layer until 2–3 mL remains in the tube, being careful not to disturb the cell layer. Harvest the cell layer between the 30/70% density gradient using a 1 mL pipette and transfer to a new 15 mL conical tube.
11. Using a 10 mL serological pipette, add RPMI 10% FCS media to bring the final volume to 15 mL. Centrifuge 450 x g for 5 min at 4 °C.
    NOTE: During this step, cell layers from two tubes can be pooled if needed. Do not pool more than two tubes or the cells will not pellet due to a high-density gradient media concentration.
12. Aspirate the supernatant carefully to not disturb the cell pellet. Resuspend the cells in an appropriate volume/buffer to count the cells using a hemocytometer (e.g., resuspend a single spinal cord in 250 µL of FACS buffer for downstream surface staining) (Figure 1).
13. Using a 1 mL pipette, transfer the cell suspensions to the top of a filter top tube (Table of Materials) and allow the cells to filter to the bottom of the tube to remove any remaining myelin debris.
14. Using trypan blue exclusion dye, dilute it and count the cells on a hemocytometer by averaging at least two 16-square grids for accuracy40,41.
15. Proceed with the desired single-cell analysis technique.
    NOTE: Using various forms of collagenase (i.e., D, type I, type II, type IV), immune cells, microglia (Figure 1), astrocytes, pericytes, endothelial cells49, and neurons50 can all be efficiently isolated. Nucleated cell counts obtained for the results were as follows using the titrated collagenase I enzyme: Whole sham-treated brain = 500,000–600,000 cells; Whole TMEV-IDD brain = 800,000–1,000,000 cells; Whole sham-treated spinal cord = 150,000–200,000 cells; Whole TMEV-IDD spinal cord = 300,000–400,000. Cell counts will vary depending on the precision of collection, processing, and whether CNS inflammation is present.

Resultaten

Figure 1: Identification of CD45hi infiltrating immune cells in CNS tissues. (A) Gating strategy for the identification of CD45hi infiltrating immune cells (P1), CD45lo microglia (P2), and CD45- oligodendrocytes, astrocytes, and neurons among total liv...

Materialen

Lijst van materialen gebruikt in dit artikel

Naam	Bedrijf	Catalogusnummer	Opmerkingen
Bovine Serum Albumin	ThermoFisher Scientific	37002D
Centrifuge	Beckman Coulter	Allegra X-12R centrifuge
Collagenase I	Worthington	LS004196
Conical tube, 15 mL	VWR	525-1069
Conical tube, 50 mL	VWR	89039-658
Cover glass	Hauser Scientific	5000
Curved forceps	Fine Science Tools	11003-14
Disposable polystyrene tube, 14 mL	Fisher Scientific	14-959-1B
DNase I	Worthington	LS002139
Dry ice	Airgas	N/A
Durmont #7Forceps	Fine Science Tools	11271-30
EDTA disodium salt dihydrate	Amresco	0105-500g
Ethanol, 100%	any	N/A
Filter top tube, 5 mL	VWR	352235
Fixable viability stain 780	Becton Dickinson	565388
Glucose	Fisher Chemical	D16-500
Hank's Balnced Salt Solution (HBSS)	Corning	21-020-CV
Hemacytometer	Andwin Scientific	02-671-51B
Hemostat	Fine Science Tools	13004-14
HEPES (N-2-hydroxyethylpiperazine-N-2-ethane sulfonic acid)	ThermoFisher Scientific	15630080
KCl	Fisher chemical	BP366-500
KH2PO4 (anhydrous)	Sigma Aldrich	P5655-100G
Liquid Nitrogen	Airgas	N/A
Mouse FC block (CD16/32)	Becton Dickinson	553141
Na2HPO4 (anhydrous)	Fisher Chemical	S374-500
NaCl	Fisher chemical	S671-500
Needle, 25 gauge	Becton Dickinson	305122
Normal mouse serum	ThermoFisher Scientific	31881
Nylon mesh strainer	VWR	352350
OCT	Sakura	4583
Paraformaldehyde, 20%	Electron Microscopy Sciences	15713-S	Diluted to 4% using 1 x PBS
Pasteur pipette, 9 inch, unplugged	Fisher Scientific	13-678-20C
PBS (1x)	Corning	21-040-CV
PE Rat Anti-Mouse CD4	Becton Dickinson	553730
PE-CF594 Rat Anti-Mouse CD19	Becton Dickinson	562329
Percoll density gradient media	GE healthcare	17-0891-01
PerCP-Cy5.5 Rat Anti-Mouse CD45	Becton Dickinson	550994
Petri dish, 100 mm	VWR	353003
pH meter	Fisher Scientific	13-636-AB150
Pipet-Aid	Drummond Scientific Corporation	4-000-101
Pipette 200 µl	Gilson	FA10005M
Pipette tips, 1 mL	USA Scientific	1111-2831
Pipette tips, 200 µl	USA Scientific	1111-1816
Pipette, 1 mL	Gilson	FA10006M
Prolong Diamond mountant with DAPI	ThermoFisher Scientific	P36962
Purified Rat Anti-Mouse CD16/CD32	Becton Dickinson	553141
Rabbit anti-mouse CD3 (SP7 clone)	Abcam	ab16669
Rabbit anti-mouse laminin	Abcam	ab11575
Rat anti-mouse ERT-R7	Abcam	ab51824
RPMI 1640	Corning	10-040-CV
Serological pipet, 1 mL	VWR	357521
Serological pipet, 10 mL	VWR	357551
Serological pipet, 5 mL	VWR	357543
Sodium hydroxide	Fisher Scientific	S318-100
Sucrose	Fisher chemical	S5-500
Surgical scissors	Fine Science Tools	14001-16
Surgical scissors, extra fine	Roboz	RS-5882
Syringe, 10 mL	Becton Dickinson	302995
Syringe, 5 mL	Becton Dickinson	309646
Trypan blue	Gibco	15250-061