Question 1

Why is borosilicate glass preferred over soda-lime glass in chemistry labs?

Accepted Answer

Borosilicate glass contains small amounts of boron, giving it a very low coefficient of thermal expansion that prevents cracking under rapid temperature changes. Soda-lime glass, the least expensive option, cracks easily when exposed to sudden heating or cooling. This makes borosilicate glass ideal for thermally stressful laboratory procedures where temperature fluctuations occur.

Question 2

What is the difference between volumetric glassware marked TD and TC?

Accepted Answer

TD (To Deliver) glassware is calibrated to accurately transport a measured volume from one container to another, such as volumetric pipettes. TC (To Contain) glassware is calibrated to be accurate only while holding the measured volume, like volumetric flasks. Understanding this distinction ensures proper measurement accuracy in experiments requiring high precision.

Question 3

When should you use a graduated cylinder versus a volumetric flask?

Accepted Answer

Graduated cylinders measure semi-precise volumes and are versatile for general delivery tasks. Volumetric flasks provide an order of magnitude greater precision and are used specifically to make and contain solutions of exact volumes. Choose graduated cylinders for routine measurements and volumetric flasks when high accuracy is essential for procedures like preparing solutions and concentrations molarity molality mole fraction calculations.

Question 4

What is fused silica used for in the laboratory?

Accepted Answer

Fused silica, or fused quartz, is chemically pure silicon dioxide with no impurities and a melting point above 1,600 degrees Celsius. It is used when glassware must be heated above 450 degrees Celsius or needs to be transparent to ultraviolet light. Unlike borosilicate and standard glass, fused silica appears optically clear and colorless when viewed down its long axis.

Question 5

How are different types of funnels used in laboratory procedures?

Accepted Answer

Standard funnels are used for gravity filtration with folded filter paper. Powder funnels have wider stems designed for dispensing solids and viscous liquids. Separatory funnels separate immiscible liquids of different densities through a stopcock at the bottom. Each funnel design matches its specific procedural purpose, from simple pouring to complex liquid-liquid extractions.

Question 6

Why should a round-bottom flask never be filled more than 50% full?

Accepted Answer

Round-bottom flasks are designed for even heating and stirring to drive chemical reactions. Filling them beyond 50% capacity risks spills during heating and stirring, which can damage equipment, contaminate samples, and create safety hazards. The 50% limit ensures safe operation while maintaining the flask's effectiveness for controlled heating and reaction conditions.

Question 7

What role do stoppers and joint grease play in connecting glassware?

Accepted Answer

Rubber and neoprene stoppers seal glassware with standard necks and can accommodate tubes or thermometers while maintaining an airtight seal. Glass stoppers seal ground glass fittings but require joint grease to prevent seizing. Joint grease is also essential when connecting two pieces of glassware together, though plastic connector clips provide additional mechanical support for these joints.

Gemeenschappelijke laboratoriumglaswerk en gebruik - Beoordelingsquiz