Question 1

What are the main components of a Schlenk line?

Accepted Answer

A Schlenk line consists of a dual manifold with two glass tubes: one connecting to a vacuum pump and the other to an inert gas source. A two-way valve allows access to either the vacuum line or inert gas line, but never both simultaneously. A Schlenk flask or other apparatus connects to this manifold to enable safe handling of air- and water-sensitive chemicals.

Question 2

Why is a cold trap used in the vacuum line?

Accepted Answer

The cold trap, a glass container submerged in liquid nitrogen, freezes volatile organic compounds sent from the evacuated Schlenk flask. This protects the vacuum pump from damage and prevents user exposure to hazardous vapors. The cold trap is essential for safe operation when working with air-sensitive reagents.

Question 3

What safety precautions should be taken before operating a Schlenk line?

Accepted Answer

Check tubing for tears or defects, ensure sufficient oil in the bubbler, and verify that check valves and pressure relief valves are undamaged. Dry glassware by oven- or flame-drying and inspect for cracks. Apply vacuum grease to glass interfaces and seal the Schlenk flask with a rubber septum or ground glass adapter before connecting to the line.

Question 4

How can liquid oxygen formation be prevented in the cold trap?

Accepted Answer

Start the vacuum pump and evacuate the vacuum line before submerging the cold trap in liquid nitrogen. Never allow the cold trap to contact liquid nitrogen unless the pump is running, and never open the vacuum line to air while the Dewar is in place. Check for light blue liquid in the trap; if detected, keep the apparatus under vacuum and call for assistance.

Question 5

What is the correct inert gas flow rate when using a Schlenk line?

Accepted Answer

The inert gas flow rate should be approximately one bubble per second when the Schlenk flask is open to the line, and slightly greater when closed. Bubbling should be continuously visible at the oil bubbler. If no bubbles appear, close the inert gas source immediately to prevent line over-pressurization and potential equipment damage.

Question 6

What personal protective equipment is required when working with a Schlenk line?

Accepted Answer

Wear safety goggles or a face shield, a flame-proof lab coat, and cryogenic gloves when handling liquid nitrogen. Operate the Schlenk line inside a fume hood with the sash lowered for protection. A blast shield may be used additionally when handling very sensitive reagents to minimize exposure risk.

Question 7

Why should the valve be turned slowly when purging a Schlenk line?

Accepted Answer

Turning the valve slowly prevents glassware from cracking due to rapid pressure changes. Before adding reagents, expose the Schlenk flask to the inert line gradually to prevent depressurization of the inert gas line. This careful pressure management protects equipment integrity and ensures safe handling of air- and water-sensitive chemicals.

Hanteren van lucht- en watergevoelige chemicaliën met behulp van een Schlenk-lijn - Beoordelingsquiz