Question 1

Why does inviscid potential flow theory predict zero drag on a cylinder?

Accepted Answer

Inviscid potential flow theory assumes no fluid viscosity, resulting in symmetric pressure distribution both horizontally and vertically around the cylinder. This symmetry produces equal pressure forces upstream and downstream, yielding zero net drag. However, real fluids have viscosity, which causes boundary layer formation, flow separation, and pressure differentials that generate significant drag forces.

Question 2

What role does the Reynolds number play in cylinder flow patterns?

Accepted Answer

The Reynolds number, a dimensionless ratio of inertial to viscous forces, determines flow characteristics around a cylinder. Below Reynolds number 4, minimal flow separation occurs. Between 4 and 40, fixed vortex pairs form in the wake. Higher Reynolds numbers produce vortex shedding with alternating vortices, eventually transitioning to turbulent, disorganized wake patterns at very high Reynolds numbers.

Question 3

How does viscosity affect the flow around a cylinder compared to ideal theory?

Accepted Answer

Viscosity creates a boundary layer along the cylinder surface, causing skin friction drag from fluid moving across the object. In bluff bodies like cylinders, viscosity also causes flow separation and low-pressure wakes behind the object, generating form drag from pressure differentials. These viscous effects produce asymmetric pressure distributions and significant drag forces absent in inviscid theory.

Question 4

What is the relationship between boundary layer transition and drag reduction?

Accepted Answer

When flow disturbances trigger early boundary layer transition from laminar to turbulent, the turbulent flow wraps around the cylinder longer before separation occurs. This creates higher back pressure in the wake, reducing the pressure differential and lowering overall drag. This principle explains why golf ball dimples reduce drag by promoting turbulent boundary layer flow.

Question 5

How is the drag coefficient calculated from pressure measurements?

Accepted Answer

The drag coefficient is calculated using pressure measurements at each port, the angular position and distance between ports, the gage pressure values, and the cylinder radius. These parameters are combined in a formula that integrates pressure forces around the cylinder surface. The resulting non-dimensional drag coefficient allows comparison between different flow conditions and cylinder configurations.

Question 6

What experimental setup is used to measure pressure distribution on a cylinder?

Accepted Answer

A wind tunnel with a 1 ft by 1 ft test section houses an aluminum cylinder with 24 pressure ports. Tubes from each port connect to a 24-column manometer panel that displays pressure readings. The cylinder is mounted on a turntable with port zero facing upstream, allowing systematic measurement of pressure distribution at different angular positions around the cylinder surface.

Question 7

Why does flow separation occur on bluff bodies like cylinders?

Accepted Answer

Bluff bodies lack streamlined shapes, so the boundary layer cannot maintain contact with the surface as pressure increases downstream. Viscous forces cause the flow to separate from the surface, creating a low-pressure wake region behind the object. This pressure differential between the front and back of the cylinder generates form drag, the dominant drag component on bluff bodies.

Kruis-cilindrische stroming: meting van drukverdeling en schatting van weerstandscoëfficiënten - Beoordelingsquiz