Atoms and molecules exhibit very interesting behavior when they absorb and release energy. The electrons in an atom traditionally exist at their lowest energy state, called the ground state, and labeled as n equal to one. However, when an atom absorbs energy, the electrons become excited and move to a higher energy level. When the electrons relax down to either a lower energy state or to the ground state, the excess energy is released as emitted light.
You may be familiar with these energy states, as they are depicted in the Bohr Model, which describes an atom as a nucleus with orbiting electrons in shells or orbitals. These shells are the same as the energy levels and are labeled by n. The wavelength of the emitted light depends on the difference between the high and low energy levels. High energy emitted light results from electrons relaxing from a higher energy level, and low energy emitted light results from electrons relaxing from a lower energy level.
The emission spectrum is a measure of emitted radiation across a range of wavelengths. With pure elemental species, the emission behavior appears as lines of specific wavelengths rather than a broad spectrum. Since different atoms have different energy levels, these spectral lines vary from element to element and depend on the transitions those electrons make between energy states when excited. For example, there are six named series of spectral lines for hydrogen, one of which is the Balmer Series.
The Balmer Series of spectral lines occurs when electrons transition from an energy level higher than n = 3 back down to n = 2. The visible light spectrum for the Balmer Series appears as spectral lines at 410, 434, 486, and 656 nm. The h alpha line is the red line at 656 nm and occurs due to the transition from n= 3 to n = 2. The cyan, blue, and violet lines correspond to energy level transitions from n = 4, 5, and 6, respectively, back down to n = 2. Additional spectral lines can be measured outside of the visible range.
Johann Balmer quantified the visible lines using the Balmer formula. Here, lambda is the observed wavelength, c is a constant, n is the lower energy level of two, and m is the higher energy level. The combination of the Balmer equation and the Bohr Model gives us the Rydberg equation, which describes the spectral lines of many different elements. In this equation, lambda is the recorded wavelength, and RH is the Rydberg constant. The initial levels marked by n-initial represent the higher energy level that the electrons excite to and n final is the lower energy level that the electrons relax back to. For the Balmer series, nfinal = 2.
In this lab, you will measure and observe the emission spectrums of hydrogen, helium, and neon and use the Rydberg Equation to determine the location of the spectral lines.
The Bohr Model
Niels Bohr proposed a model for the hydrogen atom in 1913 that described discrete energy states are associated with a fixed electron orbit around the nucleus. Importantly, an atom cannot discharge energy while its electrons are in stationary states. An electron can only emit energy by changing energy states. To change energy states, an electron must move from one orbit to another by either absorbing or emitting energy. This change can only occur if the absorbed or emitted energy equals the difference between the two states. Electrons cannot exist between orbits.
The quantum number, n, is used to label the different energy states. The lowest energy state is the ground state, which is n equal to one. The excited states are labeled n equal to 2, 3, 4, and so on. When an electron at the ground state absorbs a photon whose energy equals the difference between the ground and second state, the electron becomes excited and transitions from the ground state to the n= 2 excited state. If the energy of the photon equals the difference between the ground and third state, the electron moves to the n=3 state.
According to Bohr’s model, the potential energy of an electron in the nth level can be calculated using the following equation:
where En is the potential energy, R is the Rydberg constant (1.0974 × 107 m-1), h is Planck's constant (6.62607004 × 10-34 m2·kg/s), and c is the speed of light (~ 3 × 108 m/s). Electrons can also spontaneously return to the ground state or any other lower excited state. When this happens, the excess energy is released in the form of an emitted photon. The energy of the photon is equal to the energy difference between the higher and lower energy states. That energy corresponds to wavelengths of light. Since each type of atom has different energy levels, the light emitted from each transition varies for each atom. For a sample of mixed molecules, the emitted light contains a range of wavelengths in what is called a continuous spectrum. For a sample containing atoms of a single element, the emitted light contains only certain wavelengths, which can be viewed as discrete lines once separated by a prism.
The Hydrogen Atom
Looking specifically at the hydrogen atom, the excitation of its electrons requires the absorption of sufficient energy to split the bond in the diatomic molecule H2. Since more energy is used to split the molecule than needed, the electrons in the hydrogen atom absorb the excess energy and are excited to a higher energy level. When the electrons spontaneously return to a lower energy level, light is emitted, which corresponds to the energy difference between the excited level and lower level.
When discussing the emission of energy, the higher energy level is considered the initial level, or ni, while the lower level is considered the final level, or nf. The wavelengths of emitted light ultimately depend on the energy difference between the two levels.
In a pure sample of hydrogen gas, the emission spectrum appears as distinct lines of discrete wavelengths that are specific to the element hydrogen. Some of these lines are in the visible range of the electromagnetic spectrum, while some are in the ultraviolet or infrared range.
The Balmer Series
The series of visible lines in the hydrogen atom spectrum are named the Balmer series. This series of spectral emission lines occur when the electron transitions from a high-energy level to the lower energy level of n=2. Johann Balmer observed these spectral lines at 410.2 nm, 434.1 nm, 486.1 nm, and 656.3 nm, which correspond to transitions from the n=6, n=5, n=4, and n=3 energy levels to the n=2 level, respectively.
Balmer was able to relate these wavelengths of emitted light using the Balmer formula.
Here, λ is the observed wavelength, C is a constant (364.50682 nm), n is the lower energy level with a value of 2, and m is the higher energy level, which has a value greater than 3. This observation was then refined by Johannes Rydberg, where R is the Rydberg constant.
Remember that this equation describes emitted light, so the higher energy level is considered the initial level, or ni, while the lower level is considered the final level, or nf. In the case of the Balmer series, nf is equal to 2. This equation was combined with the Bohr model to calculate the energy needed to move an electron between its initial and final energy levels, ΔE.
Later, other spectral series for the hydrogen atom were discovered. For example, the Lyman series contains emission lines with energies in the ultraviolet region.
References
- Kotz, J.C., Treichel Jr, P.M., Townsend, J.R. (2012). Chemistry and Chemical Reactivity. Belmont, CA: Brooks/Cole, Cengage Learning.
- Silderberg, M.S. (2009). Chemistry: The Molecular Nature of Matter and Change. Boston, MA: McGraw Hill.
Atoms and molecules exhibit very interesting behavior when they absorb and release energy. The electrons in an atom traditionally exist at their lowest energy state, called the ground state, and labeled as n equal to one. However, when an atom absorbs energy, the electrons become excited and move to a higher energy level. When the electrons relax down to either a lower energy state or to the ground state, the excess energy is released as emitted light.
You may be familiar with these energy states, as they are depicted in the Bohr Model, which describes an atom as a nucleus with orbiting electrons in shells or orbitals. These shells are the same as the energy levels and are labeled by n. The wavelength of the emitted light depends on the difference between the high and low energy levels. High energy emitted light results from electrons relaxing from a higher energy level, and low energy emitted light results from electrons relaxing from a lower energy level.
The emission spectrum is a measure of emitted radiation across a range of wavelengths. With pure elemental species, the emission behavior appears as lines of specific wavelengths rather than a broad spectrum. Since different atoms have different energy levels, these spectral lines vary from element to element and depend on the transitions those electrons make between energy states when excited. For example, there are six named series of spectral lines for hydrogen, one of which is the Balmer Series.
The Balmer Series of spectral lines occurs when electrons transition from an energy level higher than n = 3 back down to n = 2. The visible light spectrum for the Balmer Series appears as spectral lines at 410, 434, 486, and 656 nm. The h alpha line is the red line at 656 nm and occurs due to the transition from n= 3 to n = 2. The cyan, blue, and violet lines correspond to energy level transitions from n = 4, 5, and 6, respectively, back down to n = 2. Additional spectral lines can be measured outside of the visible range.
Johann Balmer quantified the visible lines using the Balmer formula. Here, lambda is the observed wavelength, c is a constant, n is the lower energy level of two, and m is the higher energy level. The combination of the Balmer equation and the Bohr Model gives us the Rydberg equation, which describes the spectral lines of many different elements. In this equation, lambda is the recorded wavelength, and RH is the Rydberg constant. The initial levels marked by n-initial represent the higher energy level that the electrons excite to and n final is the lower energy level that the electrons relax back to. For the Balmer series, nfinal = 2.
In this lab, you will measure and observe the emission spectrums of hydrogen, helium, and neon and use the Rydberg Equation to determine the location of the spectral lines.
Atoms and molecules exhibit very interesting behavior when they absorb and release energy. The electrons in an atom traditionally exist at their lowest energy state, called the ground state, and labeled as n equal to one. However, when an atom absorbs energy, the electrons become excited and move to a higher energy level. When the electrons relax down to either a lower energy state or to the ground state, the excess energy is released as emitted light.
You may be familiar with these energy states, as they are depicted in the Bohr Model, which describes an atom as a nucleus with orbiting electrons in shells or orbitals. These shells are the same as the energy levels and are labeled by n. The wavelength of the emitted light depends on the difference between the high and low energy levels. High energy emitted light results from electrons relaxing from a higher energy level, and low energy emitted light results from electrons relaxing from a lower energy level.
The emission spectrum is a measure of emitted radiation across a range of wavelengths. With pure elemental species, the emission behavior appears as lines of specific wavelengths rather than a broad spectrum. Since different atoms have different energy levels, these spectral lines vary from element to element and depend on the transitions those electrons make between energy states when excited. For example, there are six named series of spectral lines for hydrogen, one of which is the Balmer Series.
The Balmer Series of spectral lines occurs when electrons transition from an energy level higher than n = 3 back down to n = 2. The visible light spectrum for the Balmer Series appears as spectral lines at 410, 434, 486, and 656 nm. The h alpha line is the red line at 656 nm and occurs due to the transition from n= 3 to n = 2. The cyan, blue, and violet lines correspond to energy level transitions from n = 4, 5, and 6, respectively, back down to n = 2. Additional spectral lines can be measured outside of the visible range.
Johann Balmer quantified the visible lines using the Balmer formula. Here, lambda is the observed wavelength, c is a constant, n is the lower energy level of two, and m is the higher energy level. The combination of the Balmer equation and the Bohr Model gives us the Rydberg equation, which describes the spectral lines of many different elements. In this equation, lambda is the recorded wavelength, and RH is the Rydberg constant. The initial levels marked by n-initial represent the higher energy level that the electrons excite to and n final is the lower energy level that the electrons relax back to. For the Balmer series, nfinal = 2.
In this lab, you will measure and observe the emission spectrums of hydrogen, helium, and neon and use the Rydberg Equation to determine the location of the spectral lines.
Videos from this collection:
Now Playing
Balmer Series
Chemistry
81.3K Views
Lab Techniques
Chemistry
233.3K Views
Scientific Measurement and Lab Skills
Chemistry
160.4K Views
Stoichiometry, Product Yield, and Limiting Reactants
Chemistry
83.2K Views
Redox Reactions
Chemistry
129.2K Views
Ideal Gas Law
Chemistry
145.1K Views
Acid and Base Concentrations
Chemistry
116.9K Views
Buffers
Chemistry
141.8K Views
Enthalpy of Reaction
Chemistry
132.7K Views
Solubility
Chemistry
92.4K Views
Metal Flame Emission
Chemistry
75.4K Views
Beer's Law
Chemistry
83.4K Views
Concentration Dependence
Chemistry
28.5K Views
Temperature Dependence
Chemistry
30.1K Views
Galvanic Cells
Chemistry
74.1K Views
See More