Optic Nerve Sheath Point of Care Ultrasound: Image Acquisition

Summary

Point-of-care ultrasound (POCUS) of the optic nerve sheath diameter (ONSD) has been shown to be useful in identifying patients with increased intracranial pressure (ICP). However, the non-standardized technique for this POCUS has hampered its use. We present a standardized image acquisition protocol for use in the acute care setting.

Abstract

The goal of this protocol is to develop a standardized method for acquiring images of the optic nerve sheath and measuring the optic nerve sheath diameter (ONSD). Diagnostic ultrasound of the ONSD to detect intracranial hypertension has traditionally faced many problems because of methodologic discrepancies. Due to inconsistencies in the measuring techniques, the potential for ONSD to become a non-invasive bedside monitoring tool for ICP has been hampered. However, establishing a transparent, consistent methodology for measuring the ONSD would support its use as a valid and reliable method of identifying intracranial hypertension. This is important as it has both high sensitivity and specificity in acute care settings. This narrative review describes ONSD POCUS image acquisition, including patient positioning, transducer selection, probe placement, the acquisition sequence, and image optimization. Further, visual aids are provided to assist in real-time during image acquisition. This method should be considered for patients for whom there are concerns regarding intracranial hypertension but who do not have an intracranial monitor in place.

Introduction

The goal of this protocol is to allow bedside providers to rapidly evaluate patients for intracranial hypertension in a non-invasive fashion using point-of-care ultrasound. In recent years, bedside decision-making and treatment have been augmented by the emergence of point-of-care ultrasound (POCUS). POCUS involves the use of ultrasound for diagnostic or procedural guidance by a patient's primary treatment provider. This article focuses on the diagnostic POCUS of the optic nerve sheath.

The rationale behind this technique is that the optic nerve and sheath communicate with the central nervous system. Specifically, the subarachnoid space extends from inside the skull around the optic nerve. Thus, when the intracranial pressure increases, the optic nerve sheath increases in size. It has been shown in studies with magnetic resonance imaging (MRI) and computed tomography (CT) that the optic nerve does not change in size with increased ICP, but the optic nerve sheath does. The vitreous of the eye provides excellent transmission of sound waves, resulting in the optic nerve being clearly visible as a hypoechoic structure inserted on the posterior eye, with the sheath visible around it. For these reasons, ultrasound of the optic nerve sheath has been used to detect elevated ICP, thus allowing the diagnosis of potentially life-threatening instances of increased ICP¹.

However, despite its clinical significance, the proficiency of physicians in using ONSD POCUS is variable^2,3, which limits the appropriate use of this modality⁴. This study aims to describe a time-efficient yet thorough image acquisition protocol for diagnostic ONSD POCUS and to illustrate the abnormal findings commonly found in clinical practice. Multiple imaging protocols have been described in the literature, and they present variations in the structural interpretation, ultrasound settings, marker placement, and scan technique⁵. Different marker points have varying sensitivity to changes in ICP, and the placement affects the ability to distinguish between patients with normal and high ICP. For these reasons, in this paper, we outline a standard technique to obtain optic nerve sheath images and measure them consistently.

Differences in the measurement location and technique have resulted in widely different thresholds of what is considered to be an abnormal optic nerve sheath^5,6. In a recent meta-analysis, the average ONSD for patients without intracranial hypertension was 4.1 mm, and the average ONSD for those with increased ICP was 5.6 mm. A generally accepted threshold for a dilated ONSD is 5.5 mm, but a change in ONSD from a normal baseline is much more predictive if a baseline is available. In the context of severe TBI, the ONSD of both eyes seems to change together⁷. There are some individual cases of increased ONSD on one side, but this is rare⁸.

There are additional challenges in the measurement of ONSD in the severe traumatic brain injury (TBI) population. Patients with severe TBI (defined as having a Glasgow coma score of <8) are not alert enough to follow commands. This means a different approach is required to measure the nerve in this population compared to in patients being evaluated in an ophthalmology office in an elective fashion for neuritis. An A-scan can be used to measure the optic nerve in a cooperative patient that can hold their eye still for a length of time, but this is not a useful technique in TBI patients, so a B-scan is the standard technique (see step 2.7 below).

The use of this method and protocol should be considered for patients for whom there are concerns regarding intracranial hypertension but who do not have an intracranial monitor in place. Specific patient populations that may benefit are trauma patients with a clinical concern for traumatic brain injury in the prehospital or emergency room setting. Additionally, patients in the ICU with a sudden change in neurologic status are good candidates for ONSD POCUS.

Protocol

This procedure is in accordance with the ethical standards of the institutional committee on human experimentation and with the Helsinki Declaration of 1975. Ultrasound is considered minimal risk procedure, so written consent from the patient is not required.

1. Probe selection

NOTE: ONSD POCUS can be performed with a multitude of different transducers. To evaluate abnormalities in suspected cases of increased ICP, choose a linear high-frequency (5-14 MHz) probe to evaluate ONSD. The probe nomenclature varies by manufacturer; however, the linear probe will be flat and usually have an L in the probe name. Choose a probe 37 mm long or smaller. Almost any probe size can be used to obtain transverse images of the optic nerve. However, sagittal views are difficult to obtain with larger probe sizes. Using a probe 37 mm long consistently allows both transverse and sagittal images in adults, while a 55 mm probe can be used in some adults but not all. Some representative probe heads are shown in Figure 1.

1. Press the Select Scanner tab
2. Choose a linear high-frequency probe. On this machine, choose L7HD.
3. Allow the probe to connect wirelessly

2. Ultrasound setup

1. Go to presets, and choose Ocular if available. If not, choose Small Parts.
2. Check the frequency. With the scanner used in this demonstration, the frequency is visible on the lower-left side of the screen next to the frame rate. A frequency of 10 MHz can be found with most bedside linear scanners in an intensive care unit, but frequencies from 5-14 MHz can be used.
3. Set the depth to 4 cm for most adult patients. The depth is seen on the right side of the image and can be adjusted on this model by scrolling up or down with a finger on the touchscreen.
4. Set the focal zone to 2.5 cm. This is noted by the arrow on the depth ruler.
5. Check the Mechanical Index (MI) and Thermal Index (TI). If using an ophthalmic setting, these will display on the image. Ensure to keep the MI < 0.23 and the TI < 1.0. Further, ensure that the acoustic output (AO) is in the range of 20%-25% power.
   NOTE: One key difference from cardiac or abdominal scanning is the lower power that should be used in ophthalmic scanning. While little attention is paid to MI and TI in most point-of-care ultrasound applications, it is important in ophthalmic imaging. To avoid damage to the delicate ocular structures, the MI and TI must be kept below the levels described above. If an ophthalmic preset is available, this will be the default. If it is not available on the scanner, the small parts setting can be used.
6. Set the length of the video capture to at least 4 s.
7. Set the mode to B-mode, 2-dimensional greyscale ultrasound.
   ​NOTE: Although A-mode (1-dimensional) scans are traditionally used for ocular scans involving melanoma and retinal detachments, the measurement of the ONSD is best done in B-mode. Additionally, the motion (M) mode is not valuable for measuring the ONSD.

3. Patient selection

1. Inclusion criteria: Include patients with a concern for intracranial hypertension, such as severe traumatic brain injury with a Glasgow Coma Score of less than 8 or other signs of traumatic brain injury.
2. Exclusion criteria: The only real exclusion criterion is ocular trauma. Exclude patients with ocular trauma.

4. Patient positioning

1. Position the patient in the default position with the head of the bed at 30°, since most patients are in the ICU. However, the exam can be performed with the patient sitting up or supine.
   ​NOTE: In the ophthalmology office, when patients are being scanned for other indications, the patient is asked to move their eye to straighten out the optic nerve so that it heads directly posterior from the eye. However, for the indication of severe traumatic brain injury, the patient will not be able to cooperate.

5. Scanning technique

1. Apply the ultrasound gel to cover the length of the transducer, which is usually several milliliters.
2. Close the eyelid of the patient, and use a transparent film dressing to hold the eyelid closed to prevent corneal abrasion or other damage to the eye during the exam. See Figure 2.
   NOTE: In an emergency, gel can be applied directly to the eyelid while it is held closed, but this should be avoided when possible.
3. Position the probe for the transverse view. See Figure 3. Center the probe over the pupil, and sweep or fan the probe over the eye to bring the nerve into view. The globe is very hypoechoic with a distinct transition visible at the back of the eye. The optic nerve will be visible as a linear hypoechoic structure posterior to the globe. The sheath will be visible as a hyperechoic boundary of the nerve.
   NOTE: Commonly, the probe will need to be angled about 10°-15° medially to find where the optic nerve contacts the back of the globe.
4. Obtain an adequate view.
   1. Attempt to obtain a view with the nerve headed directly posterior from the back of the eye. This may not be possible in patients unable to cooperate in terms of adjusting the position of their eye.
   2. Ensure that the nerve is visible 3 mm posterior to the globe.
5. Once an adequate view is acquired, take a video.
6. Scroll back on the video until the maximum diameter of the optic nerve sheath is seen.
7. Alternatively, press the Freeze button when at the maximum ONSD, and use the review slider to ensure that the maximum ONSD has been captured. The Freeze button looks like a snowflake.
8. Measure the nerve.
   1. Press the Annotation button. Choose the Distance caliper. Using the caliper function, measure 3 mm posterior from where the optic nerve attaches to the retina (Figure 4).
   2. Press the Distance caliper again. Measure the outermost lateral borders of the optic nerve sheath. The sheath is what tends to increase in size with increasing intracranial pressure, so measuring the outer diameter of the sheath is important.
   3. Save the annotated image by pressing the Save button on the bottom right of the screen. This button looks like a camera for this brand.
9. Obtain a sagittal view.
   1. Center the probe on the eye, as seen in Figure 3B.
      NOTE: The added benefits of measuring in the sagittal plane are unclear, but it is easy to do and has a negligible risk to the patient, so it is recommended to obtain the maximum information to guide clinical decision-making if possible. Some authors⁹ average the transverse and sagittal measurements to minimize the impact of technique variability.
   2. Use the same steps as for the transverse view, specifically steps 5.3-5.8, to obtain an adequate image and measure the ONSD. It may not be possible to obtain a sagittal view if the probe is greater than 37 mm in length.

Results

There are several findings that can be seen on the POCUS of the optic nerve sheath and several pitfalls that can occur in the measurements. As can be seen in Figure 5, the nerve typically heads back from the eye at an angle when the eye is in a neutral position. In patients undergoing elective ultrasound of the eye for optic neuritis, for example, the patient is typically asked to move the eye and straighten the nerve to facilitate the measurement of the diameter along the axis of the nerve....

Discussion

The most critical steps of this protocol are ensuring the correct settings are used, such as ophthalmic or small parts, to minimize the energy transmitted to the eye. Additionally, ensuring that the optic nerve and not a blooming artifact is being measured is important.

Within diagnostic POCUS, the evaluation of the ONSD is well-suited to investigating patients with traumatic brain injury to evaluate if there is increased ICP. Although invasive intracranial monitoring remains the gold standard...

Materials

List of materials used in this article

Name	Company	Catalog Number	Comments
Butterfly iQ+ with USB-C 2.0	Butterfly	n/a	Used to obtain one of the images
Clarius L7HD Portable Ultrasound Machine	Clarius	n/a	Used to obtain one of the images
Ultrasound Gel	Parker	n/a	Used to obtain all images
Transparent dressing	3M	9534HP	Used to protect eye