Lumber

Logs are harvested from trees, debarked, and fed through an automated saw that slices them into slabs. These slabs travel via conveyor belt to smaller saws, where they are cut into square-edged lumber of specific widths. The resulting pieces have rough surfaces and may vary slightly in dimensions from end to end.

Plainsawn lumber displays growth rings nearly flat on the board's wider face and is used primarily for structural applications due to cost-effectiveness. Quartersawn lumber aligns growth rings at approximately 45 degrees in softwoods and 60 degrees in hardwoods to the board's wider face, offering enhanced stability and appearance for flooring, trim, and siding applications.

Quartersawn lumber features growth rings aligned at 45 degrees or more in softwoods and 60 degrees or more in hardwoods relative to the board's wider face. This cutting method produces lumber with enhanced stability and superior appearance, making it ideal for flooring, trim, and siding where durability and aesthetic appeal are important.

Riftsawing is primarily applied to hardwoods, aligning growth rings at 30 to 60-degree angles to the board's wide face. This technique optimizes both aesthetic appeal and durability, making riftsawn lumber ideal for high-quality furnishings and decorative applications where appearance and durability are essential.

The cutting method significantly influences lumber's characteristics, stability, and appearance. Plainsawing maximizes efficiency and cost-effectiveness for structural use, while quartersawing and riftsawing enhance stability and aesthetics for specialized applications. Each technique caters to different construction and woodworking industry needs and requirements.

After cutting, lumber pieces have rough surfaces and their dimensions may vary slightly from one end to the other. The pieces require further processing, including surfacing and potentially seasoning, before they meet final specifications for construction or woodworking applications and use.

In quartersawn lumber, softwoods have growth rings aligned at approximately 45 degrees to the board's wider face, while hardwoods require alignment at 60 degrees or more. This difference in angle requirements reflects the distinct structural properties and dimensions lumber must meet for different applications.