Isolation and Characterization of Mouse Primary Liver Sinusoidal Endothelial Cells

Here, we demonstrate our protocol of primary mouse liver sinusoidal cell isolation or LSECs isolation. The protocol consists of liver collagenase perfusion and low-speed ultracentrifugation for non-parenchymal cell purification and CD146 magnetic bead selection. Our LSEC isolation method is highly efficient and applicable to healthy and diseased mouse liver.

The isolated LSECs display high purity and preserve the structure and function. LSECs isolated using this protocol are optimum for functional and molecular studies and multi-omics data generation. This protocol will be helpful for studying intercellular communication in the liver.

Begin by coating 10-centimeter culture dishes with three milliliters of collagen solution. Then, incubate the dishes at room temperature for one hour. After an hour, remove the excess fluid from the coated surface.

Wash the dishes with PBS three times and allow them to air dry. Set up the heated and humidified recirculating perfusion apparatus. Rinse the perfusion system using 10%bleach for five minutes.

Then, rinse the system again with sterile water for another 10 minutes. Drain the rinsing liquid as much as possible before perfusing with collagenase solution. Infuse the collagenase solution through the perfusion system to prewarm it to 37 degrees Celsius.

Set the pump rate to speed one on the speed control dial. Keep the speed the same throughout the whole procedure. Weigh the mouse for the procedure.

Then secure it to the surgical surface. Spray the mouse abdomen with 70%ethanol. Using surgical scissors, make an incision of approximately five centimeters starting from the lower part of the abdomen up to the xiphoid process.

After that, make two lateral cuts using small iris scissors on each side of the abdomen to expose the abdominal organs fully. Place the sheath of the IV catheter under the animal's back to lift and level the abdomen. Using a regular curved dressing forceps, gently pull the intestines and the stomach off to the left of the animal.

Then, place a 5-0 surgical suture under the inferior vena cava, or IVC, just below the exposed left kidney. Tie a loose hitch in the suture. Next, place another 5-0 surgical suture around the hepatic portal vein.

Place the suture just above the splenic vein branching point of the hepatic portal vein. Again, tie a loose hitch in the suture. Using the portal vein suture as tension, insert the 20-gauge IV catheter in the hepatic portal vein one centimeter below where it branches to the right and left hepatic portal vein.

Then, slide the catheter up the vein, but keep it below the branching area. Allow the blood to travel down the catheter until it begins to drip out. Secure the IV catheter with the portal vein suture.

Use an IV line to attach an IV bottle with buffer A to the catheter. Then, flush the liver with this solution while avoiding air entry into the system. Tie off the suture around the IVC below the kidney.

After that, cut the IVC below the suture to allow the animal to bleed out. Once perfusing, cut away the stomach, intestines, spleen and other entrails attached to the liver. Then, cut away the diaphragm and the major vessels from the thoracic cavity.

Remove the liver from the animal and place it on the perfusion tray. Carefully remove the IV line and hook up the collagenase solution in the recirculating chamber. Allow the liver to perfuse until the capsule becomes modeled and appears mushy.

This should typically take 10 to 15 minutes. Once digested, remove the liver from the chamber and place it on a 10-centimeter Petri dish with about 20 milliliters of serum-free DMEM. Gently pick apart the liver with a couple of pipette tips and discard the biliary tree.

After that, filter the liver suspension through a 70-micrometer cell strainer into a 50-milliliter conical tube. Centrifuge the cell suspension at 50 times G for two minutes at room temperature. Then, collect the supernatant containing non-parenchymal hepatic cells.

Centrifuge the supernatant at 300 times G for five minutes at four degrees Celsius. After that, collect the cell pellet and resuspend it in one milliliter of isolation buffer. Determine the cell number using an automatic cell counter following the manufacturer's instructions.

Next, centrifuge the cell suspension. Aspirate the supernatant entirely and resuspend the pellet with 90 microliters of isolation buffer per 10 million cells. Add 10 microliters of CD146 MicroBeads per 10 million total cells.

Mix it well and incubate for 15 minutes at four degrees Celsius. To wash the cells, add one to two milliliters of isolation buffer per 10 million cells. Centrifuge the solution at 300 times G for 10 minutes.

After that, aspirate the supernatant entirely and resuspend up to one billion cells in 500 microliters of isolation buffer. Next, prepare the separation column by rinsing it with three milliliters of isolation buffer. Apply the cell suspension onto the column stacked with 70-micrometer pre-separation filters.

Wash the column with three milliliters of isolation buffer three times. After that, remove the column from the separator and place it on a 15-milliliter centrifuge tube. Pipette five milliliters of isolation buffer onto the column.

To recover the magnetic bead-labeled cells, firmly push the plunger into the column to flush out the cells. Finally, centrifuge the cells at 300 times G for five minutes at four degrees Celsius. Isolated LSECs purity and surface markers were assessed with flow cytometry.

Data analysis and gating strategy for gated LSECs and singlets are based on forward scatter and side scatter data. Isolated LSECs were stained with a viability dye and a combination of CD45, CD146 and Stabilin-2 antibodies. Viable LSECs were gated on CD45 negative population and analyzed for CD146 and Stabilin-2 expression.

From this data, it was confirmed that the isolated LSECs had greater than 94%viability and greater than 90%purity. The LSEC-specific phenotype of the isolated cells was further confirmed using light microscopy and scanning electron microscopy. Isolated LSECs were cultured in the complete growth medium for six hours and examined by light microscopy.

The white arrows in the SEM image indicate LSEC fenestrae, which is a characteristic morphological feature of LSECs. The critical steps to ensure complete perfusion of a liver tissue are proper catheter tape positioning, avoiding the introduction of air in the catheter, and the optimum timing of collagenase digestion. High-quality LSEC acquired using our protocol will facilitate identification of the molecular mechanism of LSEC function and will improve our understanding of their role in intercellular communication in the liver, in health and in disease.