Turbinenregler-Steuerung

When electrical load increases, turbine-generator units release stored kinetic energy to meet demand. The electrical torque rises while mechanical torque remains constant initially, causing rotor deceleration and frequency drop. The governor detects this frequency deviation and adjusts mechanical power output to restore balance, stabilizing the rotor at a new steady-state operating point.

The regulation constant represents the slope of the frequency-power relationship, typically 0.05 per unit, expressed in Hz/MW. It quantifies how much mechanical power output changes in response to frequency deviation. A lower regulation constant means the governor responds more aggressively to frequency changes, improving system stability and frequency recovery after load disturbances.

When load increases, electrical torque rises to meet demand, but mechanical torque from the turbine remains constant initially. This torque imbalance causes the rotor to decelerate, reducing rotor speed and the generator frequency proportionally. The frequency drop serves as a control signal that triggers the governor to increase mechanical power output and restore equilibrium.

Wind turbines adjust power output by changing blade pitch angle rather than adjusting fuel input. When wind power exceeds rated capacity, blades are pitched to limit mechanical power. Type 3 and Type 4 wind turbines measure turbine speed and electrical output, then adjust blade angle to maintain desired power output and prevent overload.

Turbine-generator units store kinetic energy due to their rotating masses. When load increases, this stored energy is released to supply the additional demand, temporarily sustaining power output while the governor adjusts mechanical input. This energy buffer allows time for governor action to stabilize frequency and prevent immediate system collapse during transient disturbances.

The block diagram includes a regulation constant block that converts frequency deviation into power output change, a time delay block modeling governor-associated delays, and speed reference input and output power limiters. These components work together to ensure the governor responds appropriately to frequency changes while respecting physical constraints and system limits.

The steady-state frequency-power relationship shows that mechanical power changes are proportional to frequency deviation and reference power setting changes. Understanding this relationship allows engineers to predict how the system will stabilize after disturbances and design governors with appropriate regulation constants to maintain frequency within acceptable limits during load variations.