Question 1

What is the difference between liquid-liquid extraction and solid-liquid extraction?

Accepted Answer

Liquid-liquid extraction transfers a dissolved solute between two immiscible liquid phases, typically aqueous and organic. Solid-liquid extraction transfers a solute from a solid matrix into a liquid solvent through mixing and agitation. Both rely on solubility differences, but solid-liquid extraction requires filtration to separate the solid residue from the extracted liquid phase.

Question 2

Why must the two phases in an extraction be immiscible?

Accepted Answer

Immiscible phases remain separate and do not mix, like oil and water, allowing clean phase separation. If phases were miscible and completely homogeneous after mixing, the solute could not be isolated into a distinct phase. Immiscibility ensures the extracted solute concentrates in the target phase for easy recovery and analysis.

Question 3

How does solubility determine which phase a solute partitions into during extraction?

Accepted Answer

A solute partitions into the phase where it is most soluble. Very nonpolar solutes dissolve preferentially in organic phases, while very polar solutes dissolve in aqueous phases. The extraction succeeds only when the solute has higher solubility in the target phase than in the original phase, driving the transfer.

Question 4

What is the purpose of using a desiccant like calcium chloride in solid-liquid extraction?

Accepted Answer

Desiccants remove residual water from the extracted solution. If the hexane solution appears cloudy after extraction, water is present and must be removed by adding desiccant and stirring until the solution clears and the desiccant flows freely. This ensures a dry, pure extract ready for analysis.

Question 5

Why is nitrogen gas used to concentrate extracted organic compounds?

Accepted Answer

Nitrogen gas flowing through the headspace above the solution evaporates excess solvent without bubbling through the extract, which could cause loss of target compounds. This gentle evaporation concentrates the organic components to detectable levels when the original concentration is below the limit of quantification, enabling accurate analysis.

Question 6

What advantage does a Soxhlet extractor offer for solid-liquid extraction?

Accepted Answer

A Soxhlet extractor enables extraction of solutes poorly soluble in solvents by using a small amount of solvent with a large solid sample. The apparatus continuously recycles fresh solvent over the solid, maximizing contact and extraction efficiency. This is particularly useful for compounds like PCBs in fish tissue or wax in fruit skins.

Question 7

How is the extracted compound identified and quantified after solid-liquid extraction?

Accepted Answer

After extraction and concentration, the extract is analyzed using techniques like gas chromatography or mass spectrometry. For example, atrazine concentration in soil is calculated by comparing the extract's chromatographic response to atrazine standard concentrations. This quantitative analysis determines the exact amount of target compound present in the original sample. Results can be further confirmed using nuclear magnetic resonance nmr spectroscopy for structural elucidation.

Fest-Flüssig-Extraktion - Bewertungsquiz