Detection of a Target Analyte Using a Bacterial Biosensor

0 weergaven2:02 min • September 26th, 2025

Loading...
$$\rightleftharpoonup{xx}$$ $$\longleftharp{xx}$$, $$\longrightharp{xx}$$,

Begin with a tube containing a bacterial culture genetically modified to act as a biosensor.

The bacteria harbor a plasmid system with a red fluorescent protein or RFP gene under the control of a promoter. The promoter is repressed by a protein that is sensitive to the presence of a specific analyte, like lead.

Use an ethanol-based wipe to thoroughly wipe a test surface, and collect the analyte present on the surface.

Cut a small section from the center of the wipe and immerse it completely in the bacterial culture.

Incubate to facilitate the diffusion of the analyte from the wipe into the bacterial culture.

The analyte enters the bacteria and binds with the repressor protein, changing its conformation and activating the promoter.

The activated promoter initiates gene transcription, leading to the expression of the RFP.

Measure the bacterial fluorescence to ensure the presence of the analyte on the test surface.

Use an ethanol based wipe designed for removing lead to wipe all surfaces of the hands, including between the fingers. Store the wipes in an appropriately labeled sealable baggie until analysis. Use an alcohol based wipe to wipe down any large surfaces to be tested.

Use a cotton swap moistened with ethanol to wipe down any small surfaces to be tested. Wearing clean gloves and using scissors that have been cleaned with alcohol, cut a section that is approximately one square centimeter out of the center of the wipe. Then, place the cut piece of wipe, or cotton swab, directly into a culture tube containing two milliliters of the sensor bacteria, and ensure that it is completely submerged in the broth.

08:37

Microglia als een surrogaat Biosensor om te bepalen nanodeeltjes Neurotoxiciteit

Gerelateerde video's

0 Bekeken

13:42

Droge Film elektrochemische Microfluidic Biosensor fotoresist gebaseerde Platform: Apparaat Fabrication, On-chip Assay voorbereiding en werking van het systeem

Gerelateerde video's

0 Bekeken

09:33

Een anaërobe Biosensor Assay voor het opsporen van kwik en Cadmium

Gerelateerde video's

0 Bekeken

09:30

Bacteriële Detection & Identification gebruiken elektrochemische sensoren

Gerelateerde video's

0 Bekeken

03:01

Detection of Target Enzyme Expression in Genetically Modified Bacterial Cells

Gerelateerde video's

0 Bekeken

01:18

Detection of Human Fecal Metabolites Using a Bacterial Biosensor

Gerelateerde video's

0 Bekeken

04:43

β-Lactamase-Based Conductimetric Biosensor Assay for Protein-Protein Interactions

Gerelateerde video's

0 Bekeken

14:04

Biosensor voor de detectie van antibiotica resistente Staphylococcus bacteriën

Gerelateerde video's

0 Bekeken

07:22

Optische detectie van E. coli Bacteriën door Mesoporous Silicon biosensoren

Gerelateerde video's

0 Bekeken

08:06

Het gebruik van een β-lactamase gebaseerde Conductimetric Biosensor Assay voor het detecteren van biomoleculaire interacties

Gerelateerde video's

0 Bekeken

Laatst bijgewerkt: 15 augustus 2026