Generator prądu stałego

A DC generator converts mechanical energy into DC electrical energy with constant polarity, while an alternator produces AC current that varies sinusoidally. The key difference is that a DC generator uses a split ring commutator instead of slip rings. The commutator switches contacts for each half rotation, ensuring the induced emf always maintains the same polarity rather than alternating between positive and negative values.

The commutator is a split ring that functions as a periodic rotary switch, changing contacts with the brushes for each half rotation of the conducting loop. This switching ensures that the induced emf always has the same polarity. Without the commutator, the output would alternate between positive and negative values like an alternator, but the commutator rectifies the signal into unidirectional DC pulses.

The induced emf is maximum when the magnetic flux through the conducting loop is zero. This occurs when the loop rotates through the vertical position. Conversely, the induced emf is minimum when the magnetic flux is either maximum or minimum. The commutator ensures these minimum points appear as zero values rather than negative peaks, maintaining constant polarity throughout the rotation cycle.

As the conducting loop rotates in a uniform magnetic field, the magnetic flux through it changes sinusoidally. This changing magnetic flux induces an emf according to Faraday's law of induction. The magnitude of the induced emf depends on how rapidly the flux changes, which is directly proportional to the angular velocity of the loop rotation and the strength of the magnetic field.

The magnitude of induced emf is proportional to three factors: the strength of the applied uniform magnetic field, the area of the conducting loop, and the angular velocity of rotation. Increasing any of these parameters increases the induced emf. The average induced emf is calculated by replacing the sinusoidal variation with its average value, providing a measure of the generator's output voltage.

The conducting loop connects to the external circuit through a commutator and a pair of brushes. As the loop rotates and the commutator switches contacts, the brushes maintain electrical connection with the external circuit. This arrangement ensures that current flows in one direction through the external load, delivering DC power despite the alternating nature of the induced emf within the rotating loop.

The split ring commutator switches the contact points with the brushes every half rotation, reversing the internal connections at the same moment the induced emf would naturally reverse. This synchronization ensures the output terminals always receive the same polarity, converting the sinusoidal induced emf into unidirectional DC pulses that fluctuate between zero and maximum rather than oscillating between positive and negative values.