Question 1

Why is washing necessary after precipitate filtration?

Accepted Answer

Washing removes coprecipitated impurities and remaining mother liquor from the precipitate. This step is critical for gravimetric analysis because contaminants would artificially increase the final mass and compromise stoichiometric weighing accuracy. The choice of wash solution depends on precipitate type to prevent unwanted chemical changes.

Question 2

What wash solution should be used for colloidal precipitates like silver chloride?

Accepted Answer

Colloidal precipitates such as silver chloride are washed with an electrolyte, such as dilute nitric acid, to prevent peptization. Peptization is the redispersion of colloidal particles into solution, which would cause precipitate loss. The electrolyte stabilizes the colloidal particles by suppressing their charge-driven repulsion during the washing process.

Question 3

How does wash solution composition prevent solubility loss in slightly soluble precipitates?

Accepted Answer

For slightly soluble precipitates like lead sulfate, the wash solution contains a common ion to reduce solubility. Lead sulfate is washed with dilute sulfuric acid, which provides sulfate ions that shift the dissolution equilibrium leftward. This common ion effect minimizes precipitate redissolution during washing, preserving the sample mass.

Question 4

Why might wash solutions be made basic or acidic during precipitate preparation?

Accepted Answer

Basic or acidic wash solutions prevent hydrolysis of salts formed from weak acids and weak bases. For example, magnesium ammonium phosphate hexahydrate is washed with dilute ammonia solution to maintain pH and prevent hydrolysis. Controlling pH ensures the precipitate remains in its intended chemical form for accurate gravimetric analysis.

Question 5

What is the purpose of drying and ignition after washing a precipitate?

Accepted Answer

Drying removes adsorbed water and electrolyte from the washed precipitate. Ignition converts the precipitate to a suitable weighing form; for instance, heating magnesium ammonium phosphate hexahydrate at 900 °C converts it to magnesium pyrophosphate. Removing excess water ensures accurate stoichiometric analysis and reliable mass measurements.

Question 6

Why is cooling in a desiccator essential before weighing a precipitate?

Accepted Answer

After ignition or drying, the precipitate is cooled in a desiccator to prevent reabsorption of moisture from air. A desiccator maintains a dry environment using desiccant materials. Cooling in this controlled environment ensures the precipitate reaches thermal equilibrium at a constant, known mass before final weighing for gravimetric analysis.

Question 7

How does water content in precipitate crystals affect gravimetric analysis results?

Accepted Answer

Excess water in precipitate crystals, which may vary depending on heating or drying levels, prevents accurate stoichiometric analysis. Incomplete removal of water artificially increases measured mass and introduces error into calculations. Proper drying and ignition protocols ensure water is completely removed, yielding reliable quantitative results.

Промывка, сушка и возгорание осадков

Browse More Videos