Question 1

What are the main hazards of electrical current passing through the human body?

Accepted Answer

Even small currents can cause serious injury or death. Ten milliamps induces muscle contractions and loss of control, while 10 microamps through the heart causes ventricular fibrillation. High voltage and current can cause muscular spasms, burns, and cardiac arrest. Bodily contact with electricity requires immediate medical attention and careful prevention.

Question 2

What personal protective equipment and clothing should you wear when working with electrical equipment?

Accepted Answer

Wear long pants, closed-toe shoes, and appropriate personal protective equipment when handling electrical apparatus. Avoid loose clothing and remove dangling or metal accessories that could accidentally contact electricity. These precautions prevent accidental electrical contact and significantly reduce shock hazards during laboratory experiments and equipment operation.

Question 3

What are the differences between single-phase and three-phase AC power in laboratory settings?

Accepted Answer

Single-phase AC power from wall outlets delivers 120 volts with one hot line and one neutral line. Three-phase power delivers higher voltages—208, 230, or 480 volts—via three hot lines that are 120 degrees out of phase. Three-phase power provides greater power capacity but requires special training and safety precautions for handling.

Question 4

How does a DC power supply differ from a function generator in laboratory applications?

Accepted Answer

A DC power supply provides constant voltage or current to operate equipment, with adjustable output typically ranging 0 to 36 volts. A function generator produces time-varying signals like sinusoidal, triangular, sawtooth, and square waves with adjustable amplitude, frequency, and DC offset. Function generators excite circuits, while DC supplies power them.

Question 5

Why is proper grounding of equipment critical for electrical safety?

Accepted Answer

Proper grounding ensures the equipment chassis is at earth-ground potential, which prevents electrical shock. When using an oscilloscope grounded probe, connect the ground lead only to points in the circuit that are also grounded. Touching the ground lead to any other point causes a short-circuit to ground and creates a hazard.

Question 6

What precautions should you take before modifying an electrical circuit setup?

Accepted Answer

Before changing a setup, turn off or unplug all power sources used in the experiment. Assume any exposed metal carries live electricity unless verified otherwise. For experiments with accessible DC power greater than 50 volts, ensure at least two trained people are present to respond to emergencies.

Question 7

How do you properly measure voltage using a multimeter in a DC circuit?

Accepted Answer

Insert the red probe into the V Ohms contact and the black probe into the COM contact. Touch the red probe to the positive terminal and the black probe to the negative terminal of the power supply. The multimeter displays the voltage between these terminals, providing accurate measurement of electrical potential difference in circuits.

Меры электробезопасности и основное оборудование - Оценочный тест