Question 1

What is molarity and how do you calculate it for a solution?

Accepted Answer

Molarity is the most common way to express solution concentration, defined as moles of solute per liter of solution. To calculate molarity, determine the moles of solute from its measured mass and molecular weight, then divide by the total volume in liters. For example, a one molar solution contains exactly one mole of solute dissolved in enough solvent to reach one liter total volume.

Question 2

What is the difference between percent weight-volume and percent volume-volume solutions?

Accepted Answer

Percent weight-volume solutions express concentration as the weight of solid solute per unit volume of solvent, commonly used for preparing agarose gels in gel electrophoresis. Percent volume-volume solutions measure the volume of liquid solute per unit volume of solvent. The choice depends on whether your solute is a solid or liquid compound.

Question 3

When should you use serial dilution instead of parallel dilution?

Accepted Answer

Serial dilution is used when the dilution factor is too large for parallel dilution to be practical. In parallel dilution, the required volume of stock solution becomes too small to measure accurately. With serial dilution, you progressively dilute a stock solution step-by-step, using each diluted solution as the starting point for the next, until reaching your desired final concentration.

Question 4

How do volumetric containers differ from non-volumetric containers?

Accepted Answer

Non-volumetric containers like beakers and Erlenmeyer flasks are designed for mixing and storage with approximate graduations, not calibrated measurements. Volumetric labware is precisely calibrated and marked with capacity and either TC (to contain) or TD (to deliver). Volumetric flasks and graduated cylinders are TC devices, while pipettes and syringes are TD devices designed to dispense exact volumes.

Question 5

What is the meniscus and why is it important when measuring volume?

Accepted Answer

The meniscus is the curved surface of liquid where it meets the container wall, caused by surface tension. In aqueous solutions, the meniscus is concave and should be read at its lowest point for accurate volume measurement. Proper meniscus reading is critical when Q.S.'ing (adding quantity sufficient solvent to reach the graduation line) to achieve the correct final concentration.

Question 6

Which measuring device should you use for different volume ranges?

Accepted Answer

Select the smallest device that accommodates your desired volume for highest accuracy. For volumes above 50 mL, use graduated cylinders. Introduction to serological pipettes and pipettors are appropriate for 0.1 to 50 mL ranges. For 0.2 microliters to 5 mL, use micropipettors or glass Hamilton syringes when plastic tips are incompatible with your liquid.

Question 7

How are stock solutions used to prepare working solutions efficiently?

Accepted Answer

Stock solutions are concentrated, stable solutions prepared for frequent use and labeled as multiples of the final concentration, such as 10X. These can be diluted with solvent to achieve desired working concentrations. For example, one unit volume of 10X stock diluted in nine unit volumes of purified water yields a 1X working solution, making large-scale buffer preparation practical for experiments requiring substantial volumes.

Понимание концентрации и измерение объемов - Оценочный тест