25.4
Cleavage and Blastulation
After a large-single-celled zygote is produced via fertilization, the process of cleavage occurs while zygotes travel through the uterine tube. Cleava…
In human embryonic development as the fertilized zygote travels down the fallopian tube into the uterus the process of cleavage, rapid mitotic cell division that does not result in growth begins and is followed by blastulation the first stage of cellular differentiation.
At the onset of cleavage the zygote first divides within a protective membrane called the zona pellucida to form two smaller daughter cells called blastomeres. Which then go through another round of mitosis resulting in four new blastomeres that are smaller than their parent cells.
Beginning with the eight blastomere stage, compaction starts to occur. Blastomeres tightly push against each other making tight making tight junctions and becoming almost indistinguishable from one another. At the 16 blastomere stage the embryo becomes a morula and the cells continue to divide and form an outer and an inner cell layer along with an inner fluid filled cavity.
This stage of development the blastocyst stage in humans is marked by the development of the trophoblast which will will become the placenta and the inner cell mass which are the embryonic stem cells that will continue developing into the embryo. Finally, the zona pellucida will dissolve to allow the blastocyst to implant into the uterus wall and begin the gastrulation stage.
View the full transcript and gain access to JoVE Core videos
Q1: What happens during cleavage in early embryonic development?
Cleavage is rapid mitotic cell division that occurs without growth as the fertilized zygote travels through the fallopian tube. The zygote divides within the zona pellucida to form progressively smaller daughter cells called blastomeres. Each successive division produces blastomeres that are smaller than their parent cells, establishing the foundation for subsequent developmental stages.
Q2: How does compaction change the structure of the developing embryo?
At the eight-blastomere stage, compaction occurs when blastomeres tightly push against each other, becoming nearly indistinguishable. Tight junctions form among exterior blastomeres while interior cells form gap junctions allowing ion and molecule movement. E-cadherin, a calcium-dependent adhesion molecule, further stabilizes the tightly packed structure, preparing the embryo for morula formation.
Q3: What is the difference between a morula and a blastocyst?
A morula forms at approximately 32 blastomeres and marks the end of cleavage with outer and inner cell layers plus a fluid-filled cavity. The blastocyst develops further with specialized structures: the trophoblast, which becomes the placenta, and the inner cell mass containing embryonic stem cells. The zona pellucida then dissolves, allowing blastocyst implantation into the uterus wall.
Q4: When does the embryo's own genetic material take over development?
Zygotic genome activation (ZGA) occurs by the eight-cell stage of cleavage, when embryonic genes become activated. This transition shifts genetic control from maternal mRNAs to the embryo's own genes. Although maternal mRNAs are degraded, previously translated proteins may remain through later developmental stages, supporting continued growth and differentiation.
Q5: Why do mammalian embryos undergo holoblastic cleavage?
Mammals have holoblastic rotational cleavage because they possess sparse, evenly distributed yolk throughout the egg. This uniform yolk distribution allows the cleavage furrow to extend completely through the entire embryo, unlike meroblastic cleavage where the furrow cannot penetrate yolk-dense regions. This complete division pattern is essential for proper mammalian embryonic development.
Q6: What role do tight junctions and gap junctions play during compaction?
During compaction, tight junctions form among exterior blastomeres to stabilize the tightly packed structure and maintain cell-cell adhesion. Interior blastomeres form gap junctions that permit movement of ions and small molecules between cells, enabling intercellular communication. Together with E-cadherin adhesion molecules, these junctions create a cohesive, organized embryonic structure.
Q7: What structures develop during blastulation that prepare the embryo for implantation?
During blastulation, the trophoblast develops and will eventually become the placenta, while the inner cell mass contains embryonic stem cells that form the embryo itself. These specialized cell layers create distinct regions with different developmental fates. The zona pellucida dissolves at this stage, enabling the blastocyst to implant into the uterus wall and progress toward gastrulation.