Evaluation of Mammary Gland Development and Function in Mouse Models

Summary

This method describes how to dissect and assess mammary gland development and function from mice. Excised mammary glands are assessed for the degree of development using whole mount while milk ejection is evaluated using an oxytocin-based myoepithelial cell contraction assay.

Abstract

The human mammary gland is composed of 15-20 lobes that secrete milk into a branching duct system opening at the nipple. Those lobes are themselves composed of a number of terminal duct lobular units made of secretory alveoli and converging ducts¹. In mice, a similar architecture is observed at pregnancy in which ducts and alveoli are interspersed within the connective tissue stroma. The mouse mammary gland epithelium is a tree like system of ducts composed of two layers of cells, an inner layer of luminal cells surrounded by an outer layer of myoepithelial cells denoted by the confines of a basement membrane². At birth, only a rudimental ductal tree is present, composed of a primary duct and 15-20 branches. Branch elongation and amplification start at the beginning of puberty, around 4 weeks old, under the influence of hormones^3,4,5. At 10 weeks, most of the stroma is invaded by a complex system of ducts that will undergo cycles of branching and regression in each estrous cycle until pregnancy². At the onset of pregnancy, a second phase of development begins, with the proliferation and differentiation of the epithelium to form grape-shaped milk secretory structures called alveoli^6,7. Following parturition and throughout lactation, milk is produced by luminal secretory cells and stored within the lumen of alveoli. Oxytocin release, stimulated by a neural reflex induced by suckling of pups, induces synchronized contractions of the myoepithelial cells around the alveoli and along the ducts, allowing milk to be transported through the ducts to the nipple where it becomes available to the pups ⁸. Mammary gland development, differentiation and function are tightly orchestrated and require, not only interactions between the stroma and the epithelium, but also between myoepithelial and luminal cells within the epithelium^9,10,11. Thereby, mutations in many genes implicated in these interactions may impair either ductal elongation during puberty or alveoli formation during early pregnancy, differentiation during late pregnancy and secretory activation leading to lactation^12,13. In this article, we describe how to dissect mouse mammary glands and assess their development using whole mounts. We also demonstrate how to evaluate myoepithelial contractions and milk ejection using an ex-vivo oxytocin-based functional assay. The effect of a gene mutation on mammary gland development and function can thus be determined in situ by performing these two techniques in mutant and wild-type control mice.

Protocol

1. Mammary gland dissection

1. Euthanize the mouse using CO₂ inhalation. Avoid cervical dislocation if possible since it may damage major blood vessels in the neck and result in accumulation of blood around mammary glands, rendering the dissection more difficult. However, if other criteria are to be evaluated in the same mouse, such as blood levels of oxytocin, alternative euthanasia methods may be necessary, though this must be evaluated by your IACUC.
2. On a polystyrene foam wrapped in foil, place the mouse on its back and spread the four limbs. Pin firmly all four limbs using 16 to 20 gauge needles (Figure 1A).
3. Spray the mouse generously with 70% ethanol.
4. Using forceps, pull up the abdominal skin at the midline and make a small incision with sharp scissors.
5. Starting from the incision, cut the skin up to the neck of the animal while avoiding puncturing the abdominal or thoracic cavities (Figure 1B).
6. Cut the skin on the front legs to the midline incision, resulting in a "Y shape" (Figure 1B). Cut the skin on the rear limbs the same way (Figure 1B).
7. Using hemostatic forceps, gently peel the abdominal and thoracic skin to the side of the mouse. If needed, gently cut conjunctive tissue.
8. Fix the skin to the polystyrene foam using 16 to 20 gauge needles, exposing the mammary glands attached to the underside of the skin. Proceed and complete one side at a time (Figure 1C).
9. Using forceps, gently lift the mammary gland of interest and cut between the gland and the skin with small sharp scissors, starting from the outside towards the spine of the animal. Make sure you cut carefully, so no pieces of skin or muscle remain on the gland. All mammary glands (Figure 1) can be removed using this protocol, but abdominal mammary glands (#4) are best for whole mounting. The 2^nd and 3^rd glands have some interdigitated muscles and while they can be used for whole mount and histology, they might not be appropriate for all analyses.

2. Whole mount

1. At least one day prior to dissection, prepare carmine alum solution by dissolving 1g of carmine and 2.5g of aluminum potassium sulfate in 500 ml of distilled water and boil for 20 minutes in a 1 liter Erlenmeyer flask. Adjust the final volume to 500 ml with water. Filter through a Whatman paper and add a small amount of thymol (few grains) as a preservative. Refrigerate. After staining, carmine alum solution can be poured back to the stock bottle and reused many times over several weeks. Make a fresh solution when color becomes faint.
2. After excising the mammary gland from the mouse (step 1), spread it directly on a glass slide. Try to flatten it as much as possible, keeping the original in situ shape. The gland will stick on the slide nicely when properly stretched.
3. Fix the gland by immersing it, on the slide, in Carnoy's fixative (100% EtOH, chloroform, glacial acetic acid; 6:3:1) for 4 hours in the fume hood at room temperature in a jar. Note that others have used 2 hours which seems to be sufficient. Alternatively, glands can also be fixed at 4°C overnight.
4. Wash in 70% ethanol for 15 min. Then, rehydrate gradually in water by removing half of the ethanol solution from the jar and replacing it with ddH₂O. Incubate for 5 min. Repeat 3 times. Alternatively, use 70%-, 35%-, 15%- ethanol and water baths for 5 minutes each.
5. Rinse in distilled water for 5 minutes.
6. Stain in carmine alum overnight at room temperature. It should be noted that staining might take longer depending on the thickness of the gland.
7. Remove carmine alum stain to reuse and gradually dehydrate stained tissue through serial ethanol baths (50%, 70%, 95%, 100%) for 5 min each and clear in xylene, or in a non-toxic alternative such as Histo-clear, overnight. Both dehydration and clearing might also require longer incubations with thicker samples.
8. Immerse mammary gland in methyl salicylate. Mammary glands can be kept in methyl salicylate in a fume hood until images are ready to be taken.
9. Images can be taken in a fume hood with a regular digital camera positioned on a tripod (use "macro" function if available), by placing the slides on a light table. Use a dissecting microscope for higher magnification. Alternatively, mammary glands can be mounted in media such as Permount (after step 2.7) allowing for pictures to be taken outside a chemical fume hood on any imaging platform providing the mounts are sufficiently thin.
10. In order to quantify mammary gland development using whole mount, measurements such as the number of ramifications (or side-branches) along portions of the ducts, the length of the primary ducts, or a ratio of epithelial to adipose tissue area could be assessed. Finally, after photographic documentation, mammary gland whole mount can be embedded in paraffin for sectioning and conventional histological staining.

3. Oxytocin-induced milk ejection

1. Separate the pups from the dam just after they have been fed. Wait 1 hour before performing the assay.
2. Sacrifice the mother and expose the mammary glands as described before (steps 1.1 to 1.8), without removing them from the animal.
3. Start the assay by evenly dropping either PBS or the oxytocin solution directly on the mammary gland of interest, using a transfer pipette. A large spectrum of doses can be used; ˜8 pg/ml (physiological dose) is typically used. However, high non-physiological doses (up to 1 mg/ml) can be used to ensure the absence of response in genetically modified mouse models. For this procedure, it is recommended to use thoracic (#2-3) glands, using one side as a control (exposed to PBS) and the other side to test milk ejection (oxytocin exposure).
4. Incubate for 1 minute and remove the solution by carefully aspirating it with a transfer pipette. Milk entry into the ducts can be monitored by video tape recording, or by taking images before and after PBS or oxytocin exposure.

4. Representative Results:

In a good whole mount, the mammary gland is nicely spread and the epithelium ducts are easily observable (Figure 2A). If the gland is not well-spread, it can lift up in part or totally from the slide when placed in the fixative solution. The gland will then become hard and unusable (Figure 2B). Similarly, if the gland is not well dissected, either some part of the epithelium can be missing (Figure 2C) or remaining parts of the skin or abdominal muscle will interfere with the analysis of the gland (Figure 2D).

For the oxytocin assay, it is important to separate the suckling pups from the dam for the same amount of time on every occasion. In this way, you will make sure that no milk or small amounts of milk is present in the ducts prior to oxytocin exposure, but also that enough milk is present in the alveoli that can be ejected into the ducts by myoepithelial contractions (Figure 3A). If pups are removed too soon, milk can accumulate in the alveoli and in the ducts rendering the effect of oxytocin difficult to monitor (Figure 3B). Alternatively, if the experiment is performed too early after pup removal, milk won't have time to accumulate in the alveoli and oxytocin-induced contractions of myoepithelial cells won't trigger enough milk release into the ducts to be observed (Figure 3C).

Figure 1. Mouse mammary gland dissection. Pin the mouse on its back by the four limbs (A). Cut the skin first from the belly to the neck. Then make perpendicular incisions from the center of the belly to each limb, as shown by the dotted line (B). Gently peel the skin on the side of the animal and pin it, exposing the mammary glands (C).

Figure 2. Mouse mammary gland whole mount. Epithelium ducts (arrows) and the lymph node (arrowhead) are easily observed in a nicely spread mammary gland whole mount of gland #4 (A). A poorly spread mammary gland may become detached from the slide and collapsed, rendering it unusable (B). An improperly excised mammary gland can either have missing parts (C) or pieces of muscle or skin remaining (D). Note that the 2^nd and 3^rd glands have interdigitated muscle, but can still be used for whole mount or histology.

Figure 3. Oxytocin-induced milk ejection can be observed in epithelium ducts (arrows) following oxytocin exposure (A). However, if ducts are already filled with milk (arrows) at the beginning of the assay due to an inappropriately long period of latency after the last suckling of the pups, further accumulation of milk in the ducts (arrows) after oxytocin exposure is hard to observe (B). Alternatively, a short latency period after pup suckling will not allow for enough accumulation of milk into the alveoli to be properly observed in the ducts (arrows) after oxytocin exposure (C). Images were taken before and after oxytocin exposure using a numeric camera (Cybershot, Sony).

Figure 4. Schematic representations of whole mounting and oxytocin treatment assays.

Discussion

Mammary gland development and function are tightly orchestrated. Mutant mice may harbor gene mutations that can impair mammary gland development and function highlighting the need to evaluate gland architecture^13,12. Whole mounting can be performed as described in this article at all stages of mammary gland development. Typically, development of the epithelium is assessed at the beginning of puberty ( ˜4 weeks old), in the middle of puberty ( ˜6 weeks old) and after puberty ( ˜ 10-12 weeks ol...

Materials

List of materials used in this article

Name	Company	Catalog Number	Comments
Carmine	Sigma-Aldrich	C1022
Aluminum potassium sulfate	Sigma-Aldrich	A6435
Thymol	Sigma-Aldrich	T0501
Methyl salicylate	Sigma-Aldrich	M6752
Oxytocin	Sigma-Aldrich	O3251