Effects of Different Connection Modes of Electroacupuncture on Electrocardiogram and Nerve Discharge in Rats

Summary

Until now, there is no uniform method for electroacupuncture connection in clinical and fundamental research. We present a protocol that attempted to compare the effects of different connection methods on electrocardiogram (ECG) and neural discharge in rats to explore the most appropriate way to connect the electroacupuncture instrument.

Abstract

Electroacupuncture (EA) is one of the most commonly used methods in acupuncture and has a good effect on pain, depression, sensory movement disorders, and other diseases. The effectiveness of EA is influenced by many factors, such as the accuracy of acupoint selection, the duration and course of EA treatment, and EA parameters. However, it has rarely been discussed whether the positive and negative electrodes of the EA instrument with acupoints at different locations and distances have an effect on the curative effect. In this experiment, we observed the effects of connecting the EA instrument to acupoints at different positions and distances on ECG and vague nerve discharge in rats and preliminarily explained whether the electric field formed by different modes of EA connection has an effect on the function of the body. The connection modes of EA in this experiment included the same acupoints on both sides of the body, the same meridian or different meridian acupoints on the same side of the body, and two needles in the same acupoint area. The results showed that when the positive and negative poles were connected to the acupoints on both sides of the body, the recording of ECG and vagal nerve activity was disturbed (the same fore and hind limbs); when the acupoints were connected on the same side of the body, the smaller the distance between the two needles, the smaller the effect on ECG and vagal nerve activity recording, and the effect increased with increasing current; when the acupoints were in the same acupoint area, the recording of ECG and vagal nerve activity was not disturbed if the two needles did not form a short circuit.

Introduction

Electroacupuncture (EA) is a type of acupuncture therapy for the treatment of diseases by applying pulsed current output from an instrument to meridian points of the human body. EA has the advantages of stable and adjustable stimulation parameters, which can be quantified, timed, and labor-saving, and has special advantages in the treatment and scientific research of certain diseases, such as the study of the treatment mechanism for various neuralgia and acupuncture anesthesia, acupuncture analgesia and so on¹.

Some factors influence the effectiveness of EA, such as acupoint accuracy, treatment duration, and EA parameters, such as waveform, pulse intensity, and frequency. The commonly used clinical EA is a two-way EA, which causes less tissue damage and interferes less with the normal physiological functions of the human body. It can also prevent and cure diseases. Human tissues are conductors of complex electrolytes composed of water, inorganic salts, and charged colloids². When EA is applied to the human body, the charged particles in the electric field will move and cause changes in concentration and distribution that affect the function of the human body. Changes in movement, concentration, and particle distribution are the basis of EA therapy¹.

Over the past decade, the number of EA studies has increased for a number of diseases^1,2,3. Regarding the connection of the positive and negative electrodes of EA, few studies have been conducted to clarify this in detail. During EA, the positive and negative electrodes on the EA instrument should be connected to two acupuncture needles to act as electrical stimulation. At present, the common modes are as follows: two needles on each side of the body are connected to the same acupoints, and different acupoints on the same side of the body are connected¹. However, the effectiveness of these connection methods has yet to be proven. Some scientists have estimated that the two needles on each side of the body cannot be connected to the positive and negative poles; otherwise, the current would affect the heart function, but the two different points on the same side of the body can be connected to the positive and negative poles³. Some researchers believe that acupuncture needles connecting the positive and negative electrodes should be used in the single acupoint area to form electrical stimulation in the acupoint to promote meridian sensing².

Electroacupuncture at various acupoints can activate or inhibit nerve discharge^4,5. Many studies explain the stimulating effect of EA in Tsusanli (ST36) on the vagus nerve^6,7,8. However, these studies have not elaborated on the connection of EA and have not explained the differences in the effects of different modes of EA connection. Given the gap in this research, this study used electrophysiological techniques to explain the effects of different EA connections on ECG and nerve activity. The results provide further evidence for the correct connection of the EA.

Protocol

This experimental protocol was approved by the Standardized Laboratory Animal Ethics Review of Beijing University of Traditional Chinese Medicine and was conducted in full accordance with the experimental protocol (Ethical review code: BUCM-2023110901-4046).

1. Animals and grouping

1. Animals
   1. Obtain 48 healthy male SPF rats (8-week old) weighing approximately 200-240 g.
      ​NOTE: For this study, the animals were provided by the Vital River Company [Licence number: SYXK (Beijing) 2020-0033].
   2. House all rats in the Animal Experimental Center of Beijing University of Traditional Chinese Medicine. During the experiment, ensure that the rats have free access to food and water.
   3. Maintain the feeding environment based on a circadian rhythm shift of 12 h and control the ambient temperature at 23 ± 2 °C.
   4. Soak all surgical instruments in 75% alcohol and autoclave. Sterilize the animal handling rooms with UV lamps.
   5. Perform all animal surgeries under anesthesia. Anesthetize the rat with 20% intraperitoneal urethane injection (1 g/kg) and ensure the rat continues breathing spontaneously.
   6. Maintain the body temperature of the rat at 37 °C with thermostatic plates during surgery.
   7. Keep the eyes of the rat moist with erythromycin ointment during the experiment.
   8. Decapitate and kill the rats under anesthesia at the end of the experiment and store the specimens/samples as necessary.
2. Groups
   1. Group the rats randomly according to the connection modes. Allot 8 rats to each group randomly.
   2. Control group (no acupuncture): Feed the rat normally without any treatment.
   3. Group A, single acupoint in the left forelimb group: Connect the positive and negative EA electrodes to the Quchi point and 3 mm from the Quchi point, respectively (see Figure 1A). Locate the Quchi point (LI11) in the lateral anterior depression of the elbow joint and insert the needle perpendicularly to a depth of ~5 mm after positioning.
   4. Group B, two acupoints in the left forelimb group: Connect the positive and negative EA electrodes to the Quchi (LI11) and Waiguan (TE5) points, respectively (see Figure 1B). Locate the Waiguan (TE5) point outside the lower 1/6-fold point of the forearm in the radial and ulnar sutures. Insert the needle to a depth of 2 mm.
   5. Group C, the two acupoints in the left fore and hind limb group: Connect the positive and negative EA electrodes to Quchi (LI11) and Tsusanli (ST36) (see Figure 1C). Locate the Tsusanli (ST36) point 5 mm below the fibular head and posterolateral to the knee and insert the needle perpendicularly to a depth of ~1 cm.
   6. Group D, the same acupoints in both hindlimbs: Connect the positive and negative EA electrodes with bilateral Tsusanli (ST36) (see Figure 1D).
   7. Group E, the same acupoints on both forelimbs: Connect the positive and negative EA electrodes to bilateral Quchi (see Figure 1E).

2. ECG connection

1. Restrain the rats in the supine position after being thoroughly anesthetized.
2. Insert 1/2 inch acupuncture needles parallel to the skin of the right forelimb wrist, right hindlimb, and left hindlimb of the rats, avoiding the muscle.
3. Connect the needle handles to the recording electrodes: the positive (white) electrode on the right forelimb, the negative (red) electrode on the left hindlimb, and the reference electrode (black) to the right hindlimb of the rat (see Figure 2).
4. Use a physiological signal recorder to record the standard limb lead II surface ECG of rats in real time (sampling rate: 1 KHz, filtering range: low-cut filter, 200 Hz; high-cut filter, 0.8 Hz).

3. Separation of the vagus nerve and recording of the vagal discharge signals

1. Make a 2-4 cm incision along the midline of the neck between the larynx and the sternum after supine fixation of the anesthetized rats.
2. Sever the right vagus nerve trunk by approximately 1-2 cm after locating the right carotid sheath (containing the carotid artery, vagus nerve, and the sympathetic chain) (see Figure 3A).
   NOTE: The sympathetic nerve is located lateral to the carotid artery and accompanies the vagus nerve. The cervical sympathetic nerve is thin compared to the vagus nerve.
3. Connect the nerve trunk with a pair of copper hook electrodes and clamp the reference electrode to the incision to eliminate interference. Use saline to maintain vagus nerve activity throughout the experiment (see Figure 3B).
4. Cover the surface wound with mineral oil to maintain insulation between the electrode and the muscle.
5. Use a physiological signal recorder to record the nerve discharge of the rats in real time (sampling rate: 5 KHz, filtering range: low-cut filter, 100 Hz; high-cut filter, 1000 Hz).

4. EA intervention

NOTE: Acupuncture of the rats after the ECG and the vagus nerve discharge were stable.

1. Connect the two needle handles separately to the needle clips of the EA instrument.
2. Set the EA stimulation to a bidirectional square wave with a wave width of 0.3 ms. Set the stimulation intensity to 0.2 mA, the frequency to 10 Hz, and the stimulation time to 20 min.
3. Observe the changes in ECG and nerve discharge of rats under different connection modes of EA in real time. Collect the data for 30 s without any stimulation, 30 s before EA, and 30 s after EA using the physiological signal recorder.
4. Record the changes in the heart rates, ECG waveforms, and vagal discharges of the rats using recording software.

5. Statistical analysis of data

1. Compare the changes in ECG and nerve discharge in rats in different modes of EA connection (before and after EA).
2. Express all experimental data as the mean ± standard error.
3. Perform the student's t-test when the data passes the normal distribution test. Perform a paired samples t-test to compare the changes before and after EA and consider p < 0.05 as statistically significant.

Results

Effects of different EA connection modes on ECG in rats
In the Control group, the ECG of normal rats was recorded (see Figure 4A). It was found that the baseline conditions of the rats were significantly different. The heart rates of the rats ranged from 258 to 473 bpm (see Supplementary Table 1).

In Group A, the recording data were similar to the Control group....

Discussion

In this experiment, we observed the effects of the different ways of connecting the positive and negative electrodes, including the heart rate, vagal nerve activity frequency, and discharge amplitude. The results showed that when the positive and negative poles were connected to both forelimbs of the body, it affected the emission of bioelectricity. When the positive and negative poles were connected to the same side of the body, the closer the distance between the two needles, the less the effect on bioelectricity. The ...

Materials

List of materials used in this article

Name	Company	Catalog Number	Comments
Accupuncture Needle	Hwato	N/A
BL-420N physiological signal recorder	Techman	LAB-0017-0002-CDTM
Electroacupucture instrument	HANS	200A
Erythromycin ointment	Shuangji	N/A
Mineral oil	Solarbio	8012-95-1
Thermostatic rat plate	Techman	JR-30