Cochlear Size and Shape Variation from the Russian Population and a New Cochlear Parameter for a Safe Cochlear Implant Electrode Insertion

Summary

This article presents the size and shape variation of the cochlea from the Russian population. The study also reports a new cochlear parameter that defines the longest straight segment of the cochlear basal turn, with implications for safe cochlear implant electrode insertion.

Abstract

This study investigates the size and shape variation of cochleae in the Russian population. Also, introduces a new cochlear parameter that defines the longest straight segment of the basal turn, with the implication of a safe cochlear implant electrode insertion. A medical-grade, CE-marked DICOM viewer (OTOPLAN) was used to measure cochlear parameters, including A- and B-values, which define the length and width of the basal turn. The shape of the cochlear basal turn was estimated by the ratio between B-and A-values. The new cochlear parameter, I-value, defines the effective straight segment of the basal turn as the longest straight line connecting the cochlear entrance to the lateral wall at the opposite end, passing tangentially to the inner wall. Ratio between B-, and A-value determines the shape of the cochlear basal turn, with the cut-off value ≥0.75 for round-shaped and <0.75 for elliptical-shaped cochlear basal turn. CT scans of the temporal bone from 112 ears with normal inner ear anatomy were used in this study. The cochlear size of the Russian population, as measured by A-value, ranged from 8.04–10.03 mm, with a mean of 9.03 mm. The B-value ranged from 5.84–7.59 mm, with a mean of 6.70 mm. A round-shaped cochlear basal turn was observed in 48% of the population, leaving the remaining 52% of the population with an elliptical-shaped basal turn. The I-value that defines the effective straight segment of the basal turn ranged from 6.7–9.6 mm, with an average of 8.3 mm. The trend line indicates that the I-value is approximately 0.7–0.8 mm shorter than the A-value. For the first time in the literature, cochlear size, as measured by A-value, is presented for the Russian-speaking population. The round-shaped cochlear basal turn is seen in 48% of the population. The new cochlea parameter, the I-value, is approximately 0.7–0.8 mm shorter than the A-value.

Introduction

Cochlear Implantation (CI) is a prescribed treatment solution for several indications, including severe-to-profound hearing loss, partial deafness, asymmetric hearing loss, auditory neuropathy, and single-sided deafness^1,2. CI electrode insertion is a key surgical step, and preservation of intra-cochlear structures during insertion has become mandatory in every CI surgery. This is because structural damage during electrode insertion has been reported to negatively affect hearing outcomes with CI³. Intra-cochlear structural damage is influenced by multiple factors, including electrode design and stiffness⁴, insertion approach (round window vs cochleostomy)⁵, insertion speed⁶, surgeon’s skill in handling electrode insertion⁷, and anatomical variation of the inner ear⁸.

Eshraghi et al. have scaled CI electrode insertion trauma into 5 different grades (0-4). Grade 0 refers to no observable damage, grade 1 refers to elevation of the basilar membrane, grade 2 refers to rupture of the basilar membrane, grade 3 refers to electrode in the scala vestibuli, and grade 4 refers to severe trauma such as fracture of the osseous spiral lamina or modiolus or tear of stria vascularis⁹. Electrode scalar deviation (ESD) is considered grade 3 trauma, well reported in the literature, with a higher rate of ESD associated with a pre-curved peri-modiolar electrode compared to a straight lateral wall electrode^10,11. Rau et al. reported that by electrode design, a peri-modiolar electrode must be inserted inside the initial straight segment of the cochlea for a certain insertion depth before the stylet wire is pulled out to enable the electrode to curl around the modiolus wall¹². The new peri-modiolar electrode that comes with a polymer sheath follows the same technique: it enters the initial segment of the basal turn to a certain insertion depth, then the polymer sheath is pulled out so the electrode wraps around the modiolus wall¹³. This is the reason for the Contour Advance electrode from Cochlear to have a white marker in the electrode array at channel 10 from the apical end (8.5mm from the electrode tip)¹⁴, and the Mid-Scala electrode from Advanced Bionics LLC to have a blue marker at channel 5 from the apical end to indicate the electrode insertion depth before retracting the stylet wire¹⁵. In other words, these coloured markers indicate the insertion depth before the electrode tip encounters the lateral wall. Depending on the overall size variation of the cochlea, the straight segment of the basal turn will vary, and this is where the initial segment of the basal turn gains attention when it comes to the pre-curved peri-modiolar electrode.

The well-known cochlear parameters measured in the basal turn are the basal turn diameter and width, also called A- and B-values, respectively, which are useful for estimating cochlear duct length and for selecting electrode length and frequency-mapping based on cochlear size. Dhanasingh et al. reported a new cochlear parameter, the S-value, that connects the cochlear entrance to the lower end of the B-value in the straight portion of the basal turn¹⁶. But the S-value does not count if the straight portion of the cochlear basal turn extends beyond this point. This motivated us to investigate the straight segment of the basal turn from the cochlear entrance and to name it a new cochlear parameter to indicate the effective straight segment for safe insertion of the CI electrode. The measurement of the straight segment of the cochlear basal turn will be a clinically useful indicator of the insertion depth at which the CI electrode tip encounters the lateral wall during electrode insertion.

Protocol

This study was approved by the local institutional review board of St. Petersburg ENT and Speech Research Institute (IRB_23_001) to access anonymized radiographs from the image database without any patient involvement. No patient was directly involved in the study by any means. The software and equipment used are listed in the Table of Materials.

1. Data source and inclusion criteria

Computed tomography (CT) scans of potential cochlear implant (CI) candidates with normal inner ear anatomy were included in this study. Images acquired between 2000 and 2023 were provided by the Radiology Department of the St. Petersburg ENT and Speech Research Institute. Subjects diagnosed with malformed inner ear anatomy were excluded.

2. CT image acquisition and analysis

CT images were acquired using an expert-class 64-slice helical CT scanner with 64 detector channels. The slice thickness of the acquired images ranged from 0.36 mm to 1 mm. The CT images were analyzed using the DICOM viewer, OTOPLAN version 4.0 on a desktop computer workstation. No resampling or reformatting of images was required prior to analysis.

3. Cochlear measurement procedure

After loading the DICOM images in the DICOM viewer, the cochlea view is established by rotating the images using the crosshair feature. The A-and B-values were measured manually following the procedure described earlier by Escude et al.¹⁷. Briefly, the A-value is measured as the longest distance connecting the center of the round window (RW) passing through the modiolus to the lateral wall (length of the basal turn). The B-value (width of the basal turn) is measured by the straight line drawn perpendicular (90°) to the A-value connecting the lateral wall points above and below the A-value, as shown in Figure 1B. The steps for measuring the A-, B-, and I-values are available (see Table of Materials). All measurements were made by a single author (ES) supervised by another author (DA). Therefore, no intra- and or inter-rater differences were reported.

4. Determination of Cochlear shape (B/A Ratio)

Ratio between B-, and A-value determines the shape of the cochlear basal turn, with the cut-off value ≥0.75 for round-shaped and <0.75 for elliptical-shaped cochlear basal turn as first described by Khurayzi et al.¹⁸.

5. Measurement of the I-value

I-value, the new cochlear parameter, refers to the straight segment of the cochlear basal turn. This measurement is the longest straight line connecting the center of the RW entrance to the lateral wall at the opposite end, passing tangentially to the inner wall, as shown in Figure 1B. This measurement is made in the same plane as the A-and B-values.

6. Statistical analysis

Regression estimates between the I- and A-values (confidence level 0.95) were determined using the data analysis tool in Microsoft Excel for Microsoft 365 MSO (Version 2512, Build 16.0.19530.20226), 32-bit (https://www.microsoft.com/en-us/microsoft-365/excel).

Results

The data acquired is from 112 ears. Description of the data is given below:

Diameter of basal turn: A-value; Width of basal turn: B-value; Straight segment of basal turn: I-value. Of the 112 CT scans, 61 were from the left side, and 51 were from the right side. 98 ears were from bilateral CI patients, and the remaining 14 ears from unilateral CI subjects.

Basic cochlear parameters and shape of the cochlear basal turn
CT scans of the temporal bon...

Discussion

The primary aim of this study was to investigate variation in cochlear size (length (A-value) and width (B-value)) and shape in the basal turn of the Russian population. The secondary aim was to investigate the relationship between cochlear basal turn length (A-value) and a new cochlear parameter (I-value) representing the effective straight portion of the basal turn of the cochlea. The cochlear size of the Russian population is reported for the first time in the literature, with an average of 9.03 mm and a range of 8.04...

Materials

List of materials used in this article

Name	Company	Catalog Number	Comments
64-slice CT scanner (Aquilion)	Toshiba	N/A	64-detector helical CT system used for temporal bone imaging
Desktop computer workstation	N/A	N/A	Used for running OTOPLAN and image analysis
Microsoft Excel (Microsoft 365)	Microsoft	N/A	Used for statistical analysis (regression analysis; Version 2512 Build 16.0.19530.20226)
OTOPLAN (version 4.0)	Cascination AG	SWOTO01	CE-marked DICOM viewer used for cochlear measurements (A-, B-, and I-values)