מד זרם

An ammeter measures current and must be connected in series because objects in series have the same current passing through them. This placement ensures the ammeter reads the actual current flowing through the component without bypassing it, providing an accurate measurement of the circuit's current flow.

If an ammeter's resistance is not negligible, it changes the circuit's equivalent resistance and modifies the current being measured. An ideal ammeter has zero resistance, but real ammeters have finite resistance. To avoid measurement errors, ammeters are designed with negligible resistance, typically a fraction of a milliohm.

For two resistors in series, a single ammeter is needed because current is identical through both. For two resistors in parallel, three separate ammeter readings are necessary: one for the battery current and one for each resistor's current. The number of ammeters depends on the circuit configuration and measurement requirements.

A galvanometer can measure current by adding a shunt resistance in parallel with it. The parallel shunt resistor divides the current, allowing the galvanometer to measure DC currents several times greater than its full-scale deflection current. The required shunt resistance is determined by equating voltage drops across the galvanometer and shunt resistor.

The shunt resistance is calculated using the galvanometer's known full-scale deflection current and coil resistance. By placing a shunt resistor in parallel, the total current divides between the galvanometer and shunt. This allows measurement of larger currents while protecting the galvanometer from excessive current that would damage it.

Since current in a circuit travels through the ammeter, it contains a fuse to protect the meter from damage caused by excessively high currents. The fuse acts as a safety device, breaking the circuit if current exceeds safe levels and preventing internal damage to the ammeter's sensitive components.

Ammeter placement depends on circuit configuration. In series circuits, one ammeter measures the same current through all components. In parallel circuits, multiple ammeters are needed to measure total current and individual branch currents. Proper placement ensures accurate current measurement without altering the circuit's equivalent resistance or affecting household wiring and electrical safety.