זרימה למינרית יציבה בין לוחות מקבילים

The velocity profile between parallel plates is parabolic, with maximum velocity at the center and zero velocity at the plate surfaces due to the no-slip condition. The peak velocity at the center is 1.5 times the mean velocity. This parabolic distribution results from integrating the simplified Navier-Stokes equations with boundary conditions applied at both plate surfaces.

Flow rate between parallel plates depends directly on the pressure gradient and inversely on fluid viscosity. Increasing the pressure gradient or widening the plate separation enhances flow rate. The volumetric flow rate is obtained by integrating the parabolic velocity profile across the gap, showing that larger gaps and steeper pressure gradients produce proportionally greater flow volumes.

For steady, laminar flow between parallel plates, the Navier-Stokes equations simplify because velocity varies only perpendicular to the plates with no acceleration along the flow direction. The continuity equation shows no velocity change along the flow axis, and pressure gradients exist only along the flow direction. These simplifications reduce the complex nonlinear equations to a manageable form solvable through integration.

The no-slip condition states that fluid velocity equals zero at solid surfaces due to friction. In parallel plate flow, this boundary condition requires velocity to be zero at both plates and maximum at the channel center. Applying this condition during integration of the Navier-Stokes equations produces the characteristic parabolic velocity profile observed in laminar flow between plates.

The parallel plate flow analysis remains valid only for low Reynolds numbers, indicating laminar conditions. At high Reynolds numbers, turbulent flow develops and the analysis fails because the assumptions of steady, laminar motion no longer hold. Engineers must verify Reynolds number calculations before applying this model to ensure flow remains laminar in their specific applications.

Parallel plate flow analysis applies to irrigation channels, groundwater flow through soil layers, and sedimentation basins in water treatment plants. This model approximates water movement between soil particles and helps engineers design efficient drainage systems and predict groundwater movement. Understanding velocity distribution and flow rates enables better design of water conveyance and treatment infrastructure.

The peak velocity at the channel center being 1.5 times the mean velocity provides a useful relationship for flow calculations. This ratio emerges from the parabolic velocity profile and allows engineers to estimate maximum velocities from measured mean velocities. This relationship simplifies design calculations and helps predict shear stress distribution in laminar flow between parallel plates.