Lepkość roztworów glikolu propylenowego
Zaloguj się lub , aby uzyskać dostęp do pełnej treści. Dowiedz się więcej o dostępie Twojej instytucji do treści JoVE tutaj
View the full transcript and gain access to JoVE Science Education videos
Q1: What is the difference between dynamic viscosity and kinematic viscosity?
Dynamic viscosity measures the shear stress required to move fluid parallel to a plane, defined as shear stress divided by the rate of shear deformation. Kinematic viscosity is the ratio of dynamic viscosity to fluid density, representing resistance to flow due to gravity. Once dynamic viscosity is known, kinematic viscosity can be calculated by dividing by the fluid's density.
Q2: How does a Cannon-Fenske viscometer measure viscosity?
The Cannon-Fenske viscometer uses a temperature-controlled water bath with capillary tubes to measure efflux time—the time required for fluid to flow through the tube. The measured efflux time is multiplied by the viscometer's calibration constant, which is specific to the capillary glass used, to calculate kinematic viscosity. Different sized capillary tubes are selected based on the fluid's approximate viscosity.
Q3: What factors influence the viscosity of a fluid?
Viscosity is influenced by temperature, fluid density, and composition. Pressure changes have a negligible effect on viscosity. In propylene glycol solutions, viscosity increases with increasing propylene glycol concentration, allowing viscosity measurements to determine the unknown concentration of a sample through interpolation against known calibration data.
Q4: Why is viscosity measurement important in the petrochemical industry?
Precise viscosity measurement in the petrochemical industry determines crude oil composition and evaluates quality control in petrochemical products. Viscosity varies significantly from crude oil to liquid hydrocarbons and must be considered for efficient extraction, handling, and refinery operational conditions to ensure proper processing and product quality.
Q5: How is viscosity used to determine the concentration of an unknown propylene glycol solution?
First, measure kinematic viscosities of known propylene glycol solutions with varying concentrations. Plot kinematic viscosity against molarity to establish a linear relationship. Then measure the unknown sample's viscosity and use the calibration curve to interpolate its concentration. This method relies on the direct relationship between viscosity and propylene glycol concentration.
Q6: What are the key steps in preparing samples for viscosity measurement?
Check all liquid samples for lint, dust, or solid particles and filter if necessary through a centered glass filter. Clean the viscometer with water and dry it with filtered air. Select the appropriate capillary tube size based on the solution's approximate viscosity. Allow the sample to equilibrate in the temperature bath for 10 to 15 minutes before measuring efflux time.
Q7: How do rotational viscometers differ from glass tube viscometers?
Glass tube viscometers measure viscosity by timing fluid flow through a capillary tube, while rotational viscometers apply shearing forces and measure the torque required to rotate the fluid. Rotational viscometers with parallel plate geometry can measure viscosity across temperature gradients, making them suitable for applications requiring precise rheological characterization of complex fluids and convective and conductive heat transfer studies.