Isolation of Blood-vessel-derived Multipotent Precursors from Human Skeletal Muscle

Summary

Blood vessels within human skeletal muscle harbor several multi-lineage precursor populations that are ideal for regenerative applications. This isolation method allows simultaneous purification of three multipotent precursor cell populations respectively from three structural layers of blood vessels: myogenic endothelial cells from intima, pericytes from media, and adventitial cells from adventitia.

Abstract

Since the discovery of mesenchymal stem/stromal cells (MSCs), the native identity and localization of MSCs have been obscured by their retrospective isolation in culture. Recently, using fluorescence-activated cell sorting (FACS), we and other researchers prospectively identified and purified three subpopulations of multipotent precursor cells associated with the vasculature of human skeletal muscle. These three cell populations: myogenic endothelial cells (MECs), pericytes (PCs), and adventitial cells (ACs), are localized respectively to the three structural layers of blood vessels: intima, media, and adventitia. All of these human blood-vessel-derived stem cell (hBVSC) populations not only express classic MSC markers but also possess mesodermal developmental potentials similar to typical MSCs. Previously, MECs, PCs, and ACs have been isolated through distinct protocols and subsequently characterized in separate studies. The current isolation protocol, through modifications to the isolation process and adjustments in the selective cell surface markers, allows us to simultaneously purify all three hBVSC subpopulations by FACS from a single human muscle biopsy. This new method will not only streamline the isolation of multiple BVSC subpopulations but also facilitate future clinical applications of hBVSCs for distinct therapeutic purposes.

Introduction

Human skeletal muscle has been considered a clinically attractive source of stem/progenitor cells. Skeletal muscle contains not only committed myogenic progenitors, skeletal myoblasts, but also primitive myogenic stem cells, including satellite cells and muscle-derived stem cells (MDSCs)¹. The use of human muscle-derived stem/progenitor cells, autologous or allogeneic, in regenerative medicine has been extensively investigated in pre-clinical animal models and clinical trials. The regenerative applications of muscle stem/progenitor cells range from regenerating the dystrophic muscle in Duchenne muscular dystrophy (DMD) patients to repairing the injured heart in patients with heart attack.

Since the discovery of mesenchymal stem/stromal cells (MSCs) and other multipotent precursor cell populations, including bone marrow-derived multipotent adult progenitor cells(MAPCs) and adipose-derived stem cells (ADSCs), adult stem/progenitor cells have been extensively investigated to date^1-9. Nevertheless, their native identity and localization in situ have been obscured by the retrospective isolation methods. Recently, using fluorescence-activated cell sorting (FACS), we and other groups have prospectively identified and purified three multipotent precursor cell populations from blood vessels within human skeletal muscle and several other organs: myogenic endothelial cells (MECs), pericytes (PCs), and adventitial cells (ACs)¹⁰. These three subpopulations of human blood-vessel-derived stem cells (hBVSCs) can be respectively found in the three structural layers of blood vessels: tunica intima, tunica media, and tunica adventitia. More specifically, MECs and PCs are detected in microvessels and capillaries while ACs are localized in the adventitia layer of larger arteries and veins. Each precursor cell subset expresses a unique combination of cell surface antigens: MECs (CD34⁺/56⁺/144⁺/45^-), PCs (CD146⁺/34^-/45^-/56^-), and ACs (CD34⁺/31^-/45^-/56^-/146^-).

Further characterization of these hBVSC subsets revealed that all three precursor cell populations possess mesodermal developmental potentials similar to typical MSCs, including skeletal myogenesis, osteogenesis, chondrogenesis, and adipogenesis. All hBVSC subsets also exhibit classic MSC markers, including CD44, CD73, CD90, and CD105, freshly and in culture. Collectively these pieces of evidence supported the vascular origin of MSCs. Moreover, the therapeutic capacities of MECs, PCs, and ACs have recently been demonstrated in separate studies. MECs sorted from adult human muscle biopsies were shown to regenerate injured and dystrophic skeletal muscles and repair injured myocardium more efficiently than skeletal myoblasts and vascular endothelial cells (ECs). Purified PCs from different human organs have also been shown to repair/regenerate injured and dystrophic skeletal muscles and contribute to the satellite cell pool^13-16. Very recently, we have demonstrated that PCs derived from human skeletal muscle effectively repair the infarcted myocardium through indirect paracrine effect and direct cellular interactions¹⁷. ACs, on the other hand, have been either directly isolated from explanted blood vessels or purified by FACS from human adipose tissue and skeletal muscle. A notable pro-angiogenic effect of ACs was demonstrated in a mouse hind-limb ischemia model¹⁹. Furthermore, ACs have also been shown to repair infarcted myocardium more efficiently than conventional MSCs, indicating the robust therapeutic potential of ACs in ischemic tissue repair²⁰.

The current purification protocol grants simultaneous, prospective purification of MECs, PCs, and ACs from the vasculature of a single human skeletal muscle biopsy. This allows us to study and/or choose the optimal hBVSC subpopulation for distinct therapeutic purposes. Additionally, this new technique further expands the repertoire of stem/progenitor cells that can be derived from human skeletal muscle, making it an ideal source of multipotent precursor cells for regenerative medicine.

Protocol

1. Muscle Biopsy Processing

1. Preserve human skeletal muscle biopsy on ice in Dulbecco's Modified Eagle Medium (DMEM)supplemented with 5% fetal bovine serum (FBS) and 1% Penicillin-Streptomycin (P/S) during transportation.
2. After the receipt of the muscle biopsy, remove the specimen from the transportation container and wash it twice in phosphate-buffered saline (PBS) supplemented with 2% antibiotic-antifungal solution (A/A) under sterile conditions.
3. Remove the attached adipose and connective tissue with sterile scissors and forceps in DMEM supplemented with 2% A/A.
4. Remove large blood vessels under dissection microscope and subsequently cut the muscle specimen into small pieces (< 1 cm² in size).
5. Preserve cut muscle pieces (<5 grams) in 20 ml preservation medium (PM; DMEM supplemented with 10% FBS and 1% P/S) at 4 ℃ for up to 5 days.

2. Muscle Dissociation and Cell Isolation

1. On the day of cell isolation, remove muscle pieces from PM and wash twice in PBS supplemented with 2% P/S. To make the digestion solution, add type-I, type-II, and type-IV collagenases (100 mg/ml) freshly into PM.
2. Finely chop and mechanically mince muscle pieces with sterile scissors and forceps in a petri-dish with a small amount of PM until the solution passes 10 ml serological pipette with no clotting. Remove the residual adipose and connective tissue during this process. Use at least 8-10 grams of adult muscle or 2 grams of fetal muscle for each cell isolation.
3. Transfer 4-5 grams of minced adult muscle to 20 ml (or 2 grams of minced fetal muscle into 10 ml) ofthe digestion solution with a 10 ml serological pipette. Digest for 50 - 60 min at 37 ℃ on an orbital shaker at 70 - 80 rpm. Optimize cell yield and surface antigen preservation by adjusting the digestion time and/or agitation speed accordingly based on the amount of tissue. Observe the digestion status every 15-20 min until the turbidity almost clears.
4. Vigorously pipette the digested tissue 3-5 times with a 10 ml serological pipette. Add equal amount of PM to stop the reaction and then centrifuge at 400 x g for 4 min.
5. Carefully remove the supernatant; resuspend the pellet with 10 ml PM to wash, and then filtered through a 100 μm cell strainer.
6. Centrifuge at 400 x g for 4 min and carefully remove the supernatant. Resuspend pellets in erythrocyte lysis buffer (155 mM NH₄Cl, 10mM KHCO₃, 0,1mM EDTA), filter through a 70 μm cell strainer to obtain a single cell suspension, and then incubate for 10 min at RT. Filter through a 70-m cell strainer again if any precipitation is observed.
7. Centrifuge at 400 x g for 4 min and resuspend the cell pellet in 0.5 ml PBS. Count the number of cells. Obtain a total of at least 5 million cells for cell sorting. Dilute the single cell suspension to less than 5 million cells per ml with PBS for staining. Take out 50-100 μl of the cell suspension and split into 11 tubes for control stainings (unstained control, negative controls, and single-color positive controls).

3. Cell Labeling and Sorting

1. Incubate the single cell suspension for 10 min at 4 ℃ in mouse serum (diluted 1:10 in PBS) for blocking purpose if necessary.
2. Add CD34-APC,CD45-APC-Cy7, CD56-PE-Cy7, CD144-PE, and CD146-FITC (all 1:100) into the single cell suspension and incubate for 20 min at 4 ℃. For negative control, add equivalent concentrations of APC-, APC-Cy7-, PE-Cy7-, PE-, and FITC-conjugated isotype IgG antibodies and incubate for 20 min at 4 ℃. For single-color positive controls, add equivalent concentrations of CD34-APC, CD45-APC-Cy7, CD56-PE-Cy7, CD144-PE, and CD146-FITC individually into each tube and incubate for 20 min at 4 ℃.
3. After incubation, centrifuge at 400 x g for 4 min to wash. Resuspend the cell pellet in 1 - 2 ml DMEM supplemented with 5% FBS and 1% P/S. The final concentration of the cell suspension should be less than 5 million cells per ml. Add 7-AAD (1:100) and incubate for 15 min at RT for dead cell exclusion. For negative control and single-color positive controls, resuspend cell pellets in 0.5 ml DMEM supplemented with 5% FBS and 1% P/S.
4. Transfer all cell suspensions to round-bottom polystyrene flow cytometry tubes. Prepare cell collection tubes (each tube is pre-filled with 500 μl of the appropriate culture medium: MPM for MECs; EGM-2 for PCs; AC medium for ACs). Transport cell suspensions on ice to the cell sorter.
5. Run cell suspensions on the cell sorter in the order of the unstained control, negative controls, single-color positive controls, and the main cell suspension while adjusting laser intensity, channel compensation, and cell population gating stringently to maximize cell purity (please refer to articles published by JoVE and other journals for details of flow cytometry).
6. Collect desired cell populations in the appropriate collection tubes. Store collected cells at 4 ℃ if not seeding immediately.

4. Post-sorting Cell Culture

1. Seed freshly sorted MECs (P0) at <10,000 cells/cm²in MPM onto plates pre-coated with type-I collagen. For subsequent passaging of MECs, seed 3,500 - 4,000 cells/cm² in MPM onto plates/flasks pre-coated with type-I collagen.
2. Seed freshly sorted PCs (P0) at <20,000 cells/cm² in EGM-2 onto plates freshly coated with 0.2% gelatin. For subsequent passaging of PCs, split cells at 1:3 ratio in PC medium (DMEM supplemented with 20% FBS and 1% P/S) onto regular polystyrene culture plates until P2. From P3 onward, seed cells at 6,500 - 7,000 cells/cm² in PC medium onto regular polystyrene culture plates/flasks.
3. Seed freshly sorted ACs (P0) at <20,000 cells/cm² in AC medium (DMEM supplemented with 20% FBS and 1% P/S) onto regular polystyrene culture plates. For subsequent passaging of ACs, seed cells at 6,500 - 7,000 cells/cm² in AC medium onto regular polystyrene culture plates/flasks.

Results

FACS parameters are first corrected based on the data obtained from the unstained control, negative controls, and single-color positive controls. After exclusion of dead cells, fluorescence-labeled cell suspension is subjected to a series of negative and positive cell surface marker selections. First, CD45⁺ cells are gated out before CD56⁺ and CD56^- cells are separated from the CD45^- fraction. The CD56⁺ fraction is further subjected to CD34-CD144 selection where only...

Discussion

Identification and purification of hBVSC subpopulations represent a major advance in the comprehension of MSC ontogeny. There is increasing evidence indicating the perivascular origin of MSCs and the association between tissue-specific precursor cells and blood vessels^22-25. In addition, the capacity to isolate homogeneous subpopulations of hBVSCs further aids the understanding of MSC heterogeneity and vascular cell biology²⁶.

In the past few years, MECs, PCs, and AC...

Materials

List of materials used in this article

Name	Company	Catalog Number	Comments
Collagenase type 1	Sigma	C5894	Sterile vial
Collagenase type 2	Sigma	C1764	Sterile vial
Collagenase type 4	Sigma	C1889	Sterile vial
Anti-human CD34 APC	BD Pharmingen	555824	Keep sterile
Anti-human CD45 APC-Cy7	BD Pharmingen	557833	Keep sterile
Anti-human CD56 PE-Cy7	BD Pharmingen	557747	Keep sterile
Anti-human CD144 PE	Beckman Coulter	A07481	Keep sterile
Anti-human CD146 FITC	AbD Serotec	MCA2141F	Keep sterile
FACS Aria II Flow Cytometer	Becton-Dickinson
EGM-2 complete medium	Lonza	CC-3162	For culturing PCs (only P0)
DMEM high glucose (1X), liquid, with L-glutamine, without sodium pyruvate	Invitrogen	11965	For culturing PCs
DMEM high glucose (1X), liquid, with L-glutamine, with sodium pyruvate	Invitrogen	11995	For culturing MECs and ACs
Fetal bovine serum	Invitrogen	10437-028
Heat-inactivated horse serum	Invitrogen	26050-088
Penicillin/streptomycin	Invitrogen	15140-122
Antibiotic-antimycotic (100X)	Invitrogen	15240-062
Trypsin-EDTA 0.5% (10X)	Invitrogen	15400-054
Dulbecco’s PBS without calcium and magnesium	Invitrogen	14190-250
Chick embryo extract	Accurate Chemical	CE650T-10	Filter before use