Concurrent Electrical Measurements
Concurrent Electrical Measurements - Related Videos
08:59
Concurrent Quantitative Conductivity and Mechanical Properties Measurements of Organic Photovoltaic Materials using AFM
0 Views •
Cited by 3 •
2013
Organic photovoltaic (OPV) materials are inherently inhomogeneous at the nanometer scale. Nanoscale inhomogeneity of OPV materials affects performance of photovoltaic devices. In this paper, we describe a protocol for quantitative measurements of electrical and mechanical properties of OPV materials with sub-100 nm resolution.
11:02
Detection of Exosomal Biomarker by Electric Field-induced Release and Measurement (EFIRM)
0 Views •
Cited by 43 •
2015
Exosomes are microvesicular structures found within biofluids that potentially carry important disease discriminatory biomarkers. Here, a novel method is used to specifically extract exosomes and rapidly test the exosomal cargo for both RNA/protein targets following the disruption of exosomes using non-uniform electric cyclic square waves.
10:18
Concurrent Quantification of Cellular and Extracellular Components of Biofilms
0 Views •
Cited by 18 •
2013
A protocol for the concurrent quantification and comparison of three cellular and extracellular components within biofilms is presented. The methodology involves the use of confocal laser scanning microscopy, biofilm structural analysis and visualization software, and statistical analysis software.
14:16
A New Application of the Electrical Penetration Graph (EPG) for Acquiring and Measuring Electrical Signals in Phloem Sieve Elements
0 Views •
Cited by 24 •
2015
Electrical Penetration Graph (EPG) is a well-established technique for studying the feeding behavior of stylet-bearing insects. Here we show a new application of EPG as a non-invasive tool for the acquisition of intracellular electrophysiology recordings of sieve elements (SEs), the cells that form the phloem vasculature in plants.
06:51
Concurrent Electroencephalography Recording During Transcranial Alternating Current Stimulation (tACS)
0 Views •
Cited by 29 •
2016
In this article we explain how to set up a concurrent transcranial alternating current stimulation and EEG experiment.
FAQs
Synchronized sampling ensures that readings from separate channels correspond to the same points in time. This alignment prevents timing ambiguity when engineers compare voltage and current, examine phase relationships, or relate an input to a system response. It is especially important for transient analysis, where even small differences in channel timing can obscure the sequence of electrical events.
These factors determine whether the acquired signals accurately represent the circuit or system. Probe placement affects which electrical behavior each channel observes, while bandwidth must accommodate the signal features being studied. Isolation helps prevent unwanted electrical interaction between the measurement setup and the system under test. Together, they help preserve signal integrity during simultaneous acquisition.
Recording related quantities over the same interval allows engineers to examine interactions rather than isolated readings. Comparisons can expose transient responses, indicate how power moves through a system, and show relationships between feedback signals and system behavior. The same approach can also help associate unusual electrical patterns with failure conditions during testing or diagnosis.
A typical setup begins by selecting the electrical quantities to compare and assigning them to separate sensing channels. Engineers then place the probes at appropriate points, connect the channels to a common measurement system, and establish synchronized sampling or triggering. Before interpreting results, they should consider signal bandwidth and isolation so the recorded waveforms remain representative.
The approach is useful when a result depends on interactions among electrical variables rather than on one signal alone. Engineering teams can apply it to circuit characterization, control-system validation, diagnostics, and device testing. By observing related quantities together, they can evaluate operating behavior, identify responses to changing conditions, and support decisions about more reliable designs.
Correlated channel records help connect a system event with the electrical conditions occurring at the same time. Engineers can compare signals during transients, feedback behavior, or suspected failure conditions to identify patterns that separate normal operation from abnormal performance. Those observations contribute to diagnostics and provide evidence for improving device design and validating system behavior.